mer_du_sud
Occasional Visitor
Hello.
I am equipped with an ASUS AC68UF router located behind a box. I also use a VPN to access the Internet (PROTONVPN in this particular case). I switched to Merlin firmware because of the possibility to specify which devices connected to the local network will go through the VPN and which other devices will go directly to the WAN. My first attempt was not very happy: I had no more access to anything and I had to reset the router. Before trying again, I would like to avoid the same mistake. In fact, my need is basic: by default, I want all the devices to go directly on the WAN and only some of them to go through the VPN (in fact, basically all those on which it is not possible to install a VPN client). Let's assume that only the 192.168.2.50 and 192.168.2.77 devices have to go through the VPN. What should I write?
Thank you for your help.
I am equipped with an ASUS AC68UF router located behind a box. I also use a VPN to access the Internet (PROTONVPN in this particular case). I switched to Merlin firmware because of the possibility to specify which devices connected to the local network will go through the VPN and which other devices will go directly to the WAN. My first attempt was not very happy: I had no more access to anything and I had to reset the router. Before trying again, I would like to avoid the same mistake. In fact, my need is basic: by default, I want all the devices to go directly on the WAN and only some of them to go through the VPN (in fact, basically all those on which it is not possible to install a VPN client). Let's assume that only the 192.168.2.50 and 192.168.2.77 devices have to go through the VPN. What should I write?
Thank you for your help.