My main router AX86U (connected directly to the ONT) and has two ethernet connected AC68U mesh nodes. All routers are have been upgraded to Asuswrt-Merlin 386.4 firmware. I have Centurylink 940 Mbps service. When my computer is connected directly to the AX86U via ethernet, I get most of my provisioned speeds (approximately 850 up/down) using the computer’s speedtest.net program. However, when I connect via ethernet directly to either node my speeds are decreased by half. Both nodes are set up with ethernet backhaul enabled to the AX86U. Is this speed decrease normal and caused by the mesh network (even though I’m hard wired the whole way) or is something not working or set up correctly? Any suggestions to remedy this are appreciated.