craftb3ard
New Around Here
Hello all, I apologize for being so new to this. I have recently taken my TM-AC1900 and performed the following:
- Downgraded T-mobile firmware to enable telnet
- Changed bootloader to v. 1.0.2.1
- Flashed Merlin v. 376.47
I attempted to flash Merlin v. 380.58 this morning and the router just went into recovery mode. I had to re-flash 376.47 to get it to boot properly.
Am I missing something?
Also, the only way I've found to reset VRAM is to hold the WAN button while plugging in. Attempts to do it in putty (mtd-erase2 nvram) were met with NVRAM invalid command.
- Downgraded T-mobile firmware to enable telnet
- Changed bootloader to v. 1.0.2.1
- Flashed Merlin v. 376.47
I attempted to flash Merlin v. 380.58 this morning and the router just went into recovery mode. I had to re-flash 376.47 to get it to boot properly.
Am I missing something?
Also, the only way I've found to reset VRAM is to hold the WAN button while plugging in. Attempts to do it in putty (mtd-erase2 nvram) were met with NVRAM invalid command.