Hello-
Bought an AC86U and am going through setup. Been using an older AC68P and tomato and am used to entering a bunch of static dhcp addresses through the Tools-->System Commands window using 'nvram set dhcpd_static=blah blah blah, etc' because it's so much faster than doing them individually through the Basic-->Static DHCP section of the GUI.
After some searching the forum it's my understanding I need to do it this way for Merlin:
-ssh into the router
-use 'nvram set dhcp_staticlist=<mac-address-1>ip-address-1>name-1<mac-address-2>ip-address-2>name-2...etc
Do I have that correct?
Thanks!
Bought an AC86U and am going through setup. Been using an older AC68P and tomato and am used to entering a bunch of static dhcp addresses through the Tools-->System Commands window using 'nvram set dhcpd_static=blah blah blah, etc' because it's so much faster than doing them individually through the Basic-->Static DHCP section of the GUI.
After some searching the forum it's my understanding I need to do it this way for Merlin:
-ssh into the router
-use 'nvram set dhcp_staticlist=<mac-address-1>ip-address-1>name-1<mac-address-2>ip-address-2>name-2...etc
Do I have that correct?
Thanks!