Recent content by airjordanorbi

I ended up connecting via usb-ttl and even that doesn’t seem to fully load. It prints a screen but no matter how many time I try typing a selection nothing inputs in telnet - I’ve tried every pin and confirmed all wires work via a loop test.

When I plugin the device, the power led flashes temporarily a bright amber but then goes to a very very dim amber, Anybody know a fix? I am using the power adapter included and the adapter worked on another RBR750 I had laying around. I tried nmrp but its not detecting ethernet. I tried the...

Thanks! The firmware was the most up to date and the additional TWO RBS50 satellites connected without any issue. I think the RBR50 has a hardware issue.

I gave away my entire RBR40 system and replaced it with a RBR50 I scored from a friend. Yes none of the RBR40 components are involved, I've triple checked they are all now RBR50 or RBS50. I cannot get the RBR50 to notice the RBS50 as a satellite neither when the two are connected wirelessly nor...

i just set mine up to my router via moca adapters, the modem is in room on other side of house, and per speed test the nvidia got up to 750mbps - i have the 2019 version.

Iunno if you figured this out, but starting with a CLEAN slate is key and patience. Let each device boot all the way up until it stops flashing white, factory reset each device by holding down the reset button until the green light blinks orange, for the rbw the halo up top will blink orange...

UPDATE: I confirmed the ttl to usb wasn't defective by running putty and testing each cable by connecting one end of the cable in the rx slot of the adapter and the other in the tx slot - when you open the putty terminal and type, your adapter is working if you can see what you type. I tested...

Hi, I do not see anything in the prompt for putty after i power on my router (orbi rbr40) and connect to my laptop via a usb to ttl adapter. I don't see any errors show when i click 'open' on putty - I saw an error once when i inputted the incorrect COM port number. Here's my settings and...

I am unsure what happened. I enabled telnet, did putty, flashed while in recovery and now I get a 404 error when I try to go to 192.168.1.250, same error shows if i try going to the debug page. I confirmed that the router IP changed to .250 after doing cmd-ipconfig, I also pinged it and got ttl...