Menu
What's new
By:
Filters Better Search

Recent content by CodeCypherP

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. C

    so i've been running on this for a week some thoughts.....

    thats correct it is specific to Cisco but LLDP does not show up on these older switches they are IOS based not IOS-XE I too know Cisco well.
  2. C

    so i've been running on this for a week some thoughts.....

    i confirmed it works. I picked up a old 3860-cg and 2960G switches for lan networking since my apartment is wired but they didnt set it up for connected ports so i just made it connected. :) for what its worth though the firestick dongle for ethernet kinda sucks it only does 10/100 and im only...
  3. C

    so i've been running on this for a week some thoughts.....

    so yes i found a work around basically the swtichport southbound needs this config (for Cisco devices) interface GigabitEthernet0/10 description uplink asus switchport trunk encapsulation dot1q <<---- NOTE has to be set to dot1q (otherwise it assumes ISL) switchport trunk native vlan 10...
  4. C

    so i've been running on this for a week some thoughts.....

    so far I love it! but a few questions 1) i was told not to touch lldp too much... i get that but is there a way to enable Cisco CDP safely? 2) can i set my own vlans ( i get the source has vlans 501,502 ) I would rather configure my own? 3) Norhtbound i have 3560-cg (a compact L3 ) 10 x 1 gig...
  5. C

    setting LLDPD and using lldpcli - why and whats it for, also checking your config

    ah okay... i didn't realize... i turned on C mode so i can see my other Cisco switches in my topology. and yes you're correct it wasnt an article rather the man page for the cli commands
  6. C

    setting LLDPD and using lldpcli - why and whats it for, also checking your config

    depending on your need you can set up LLDP also known as Logical Link Discovery Protocol. Its in everything, Windows, switches, Linux, MacOS you name it ... it has it as a feature... This is a method for discovery to locate and find various devices on your network mostly for humans...
  7. C

    figured out how to map the ports in the AX88U to cli config (Actual)

    I'm also compiling work around commands to make a nice output like robocfg
  8. C

    figured out how to map the ports in the AX88U to cli config (Actual)

    Hoping you'd see the post.. I read a lot of replies before I joined... I'm trying to figure out how to shut down unused ports. I suspect eth5 will take out ports 5 - 8.
  9. C

    figured out how to map the ports in the AX88U to cli config (Actual)

    Hello, So i have been struggling to figure out how to disable unused onboard ports but still have them to expand as necessary so i gamed the system.. i happen to have a Cisco Catalyst switch in my house and i turned on lldpd -c whieh enables CDP neighbor port maps are as follows Physical...
See more
Top