Recent content by DarkWolfSLV

mmmm nop, still auto discovering the old settings :( my IPv6 are set to passthrough

Th Thank you for the confirmation, I applied the changes. They are reflected on /etc/dnsmasq.conf but by devices (pc, cellphone and ipad) are still getting the full IPv6 auto discovery IP. This is after a few service restarts and a reboot. Your scripts works since it applied the changes, but...

Thanks for the script! I'm not super familiar with postconf files, but I just need a *.sh under /jffs/scripts/* as explained on the Wiki, right? User scripts · RMerl/asuswrt-merlin.ng Wiki · GitHub Thank you!

Hi @RMelin I understand what you are saying, but there's no way to manipulate what Router Advertisement will deliver. At least for the DNSv6 information. Currently the ASUS insert itself as DNS server, but I would like to set it to be my IPv6 pihole address. Thanks.

Hi! Is there a way via the CLI (since it is not possible on the GUI due to the character limit) to add an IPv6 DNS server for your LAN DHCP configuration? Currently using IPv6 Passthrough but even with static IPv6 settings, the DNS information is for the Router and not the clients. Thanks.

Since the last update (386.3) all the labels and pictures for clients is no longer there (not a big deal) but when I try to set it back, is not saving the changes, could it be related?

Very interesting! Unfortunately I do not have the 386 version yet so I cannot test myself so I'll ask here. I like the idea of proper isolation with new subnets and like everyone here has mentioned, this is desired to isolate IOT devices, but what about wired devices? I would like to put my...

After some reading I came up with the below configuration. Once I set the Channel bandwidth and Control Channel to one, and only one value the WLCEVENTD went away and with that the disconnections. I tried leaving the Channel bandwidth dynamic (20/40 MHz) while changing Control Channel from auto...

I do have Smart Connect enabled. Taking into consideration Maverickcdn's comments, could you consider these events "normal" due to the nature of Smart Connect? It has not been so long to confirm if all my nodes are experiencing *drops* because of this. All my devices should be capable of...

I did a reboot, not a factory reset on the router. As you can see on the logs, the reboot happened around 10am and 2h later I still have good amount of WLCEVENTD. I do not see why a factory reset will make a difference. Thanks.

Update #2: I found this discussion where RMerlin suggests to disable a few settings which I did for 2.4ghz and 5ghz. - Disable Universal/Implicit Beamforming (Explicit is fine) - Disable Airtime Fairness - Disable MU-MIMO After 1h still having drops :( Is there a way on the CLI where I can...

A little update: still having troubles with v384.13 - all my devices are experiencing short disconnections, I can even match my phone and router logs when it happens which discards this to be a cosmetic issue.

dave14305 is correct, after the downgrade I still have some WLCEVENTD, but I do not thing they are "normal" since the devices disconnecting are Smart Speakers (2) and my cellphone to list a few. I'll keep a close eye to the performance and report back. Regards.

Having similar issues on my RT-AC86U running v384.14, but in my case all my devices eventually experience a problem. I have smart connect ON since I noticed that everything was using 2.4GHz no matter what. Example below of my smart speaker. Feb 5 11:25:20 wlceventd: WLCEVENTD...

My apologies for the delay guys, I tried both suggestions and I still cannot make it work. If I plug my PC directly to router Google Fiber gave me I do get IPv6 (the same way the router it is getting IPv6 on it's WAN interface). I'll keep it disable for the time being en revisit later. Thank...