Recent content by geoffroyg

I got rid of the error message by uncheking Enable 160 Mhz, and fixe control channel. Hope this helps

Thank you for your answer. I did downgrade to 386.5_2 and all problem solved. I found the issue, because I had to understand, what was causing those gigantic ping on my local network. The answer is Guest Network. I was using a guest network and funneled it to a wireguard VPN. I wanted to have...

Hi, I have 3 AX86U in Aimesh (wifi backhaul) Since I upgraded to 388.1, I am getting a lot of short disconnect issue on WIFI, and also very slow ping to wifi devices on the local network. No issue on ethernet. Anyone else experiencing this? If anyone has an idea of what could cause this...

No I did not… still there, but dors not seem to affect anything…

@goodwin_c I still cannot figure it out. But using nPerf instead of speedtest app, I get better download results. Maybe a speedtest issue... But I doubt, as ethernet speed has no issue... BTW, I have the same issue using iphone 12 or different ipads... so hard to pinpoint the issue. I have...

I am getting every 5-6 seconds this message in my log on Asus AX86U, Anyone knows what this refers to? Thank you Apr 17 22:48:44 kernel: CONSOLE: 166402.839 wl1: wlc_iovar_ext: dump: BCME -23 Apr 17 22:48:49 kernel: CONSOLE: 166407.905 wl1: wlc_iovar_ext: dump: BCME -23 Apr 17 22:48:55...

Just an additional information I do get 500-550 Mbits download on the Iphone using Iperf3 Lan.

Hi, Anyone else experiencing this, I have gigabit fiber connection. I get close to full gigabit speed on ethernet, but in wifi I consistently get a ration of 2:1 (200-300Mbps) Down (500-650Mpbs) Up speed. I am using an Iphone 11 Pro on Wifi. Having the same result with AX86U, and AX58U, and...

Your right! But how misleading if yiu do not know about it!

@john9527 and @ColinTaylor I figured it out! After adding my AC86U as node the channels 120 124 128 disapeared on the new router where I could see these channels before. I removed the AC86U from the mesh and the channels are available again .... Is this a bug?

but now my AC86U can only join mesh on 2.4Ghz as it cannot see the 128 Channel ... Never ending story ...

Even more strange ...I changed the control channel to 128 It just switched to 160Mhz ...

Do you think flashing an older firmware might help? or should I contact Asus? They are so difficult to get on the phone...

I did not see this dFS state in the UK one...

First Amazon UK, second Amazon Turkey