Recent content by Gregory Phillips

So far my Wi-Fi 7 devices continue to show as wireless.

Looks like they made some changes over the pulled 249 version.

Yes I see it now and was able to get it via GUI and site.

Meh you made me search for it before I read through all of the posts....:eek::p

Well today my wifi 7 devices are showing hard wired again....:eek:

This firmware fixed the issue where my 5ghz devices showed as hardwired instead of wireless but it did require a reboot.

I haven't seen anything adverse out of this firmware yet but then again the router is a node so I don't really interact with it anymore. It primarily handles appliances at the other end of the house and my robot vacuums when they go down there and I haven't received any connectivity warnings...

Thanks for the heads up as the check for update button doesn't pick up on this firmware

I've been noticing that my wifi 7 devices are showing up as hard wired in the client list. Edit: Only 2.4ghz shows up as wireless everything else shows as hard wired even though its on wifi.

This firmware appears to be working fine on my router.

Well two weeks have passed and I've not seen any issues with this firmware.

I just applied it so now we see how it behaves.

Dual WAN still working properly. 😍

I updated with fingers crossed so we'll see how it goes.

So I was thinking about how its been a while since I've tried dual wan on this router and decided to try it again today. Much to my surprise it switched over from the primary (xfinity) to the secondary (AT&T) and when I restored the primary it fell back like it was supposed to. Then I rebooted...