Recent content by IceTea

I hope not, Asus Routers are hella expensive in my country. Just the AX68U costs like $500 :confused:

Did that, still getting the same behaviour. After that, I followed your "Nuclear Reset" guide as well.

To my desktop with speed test servers that support more than 1gbps, and with a latency of ~5ms. Protocol? Eh, LAN to my desktop, and ISP uses PPPoE.

Like it says on the title, core 1 at 100% usage when downloading. Ran 'top' on the router, and the culprit is [ksoftirqd/0]. HW Acceleration is enabled. All the extra features are disabled(QoS, AI Protection, etc.) Running the latest Merlin Firmware (386.3_2) My WAN is PPPoE LAN cable is...

Damn, thanks for the help though. Would you rec the AX86U or a USG from Ubiquity?

Actually tried that, but speeds went down... They did just get back to me, and they think my FNO might have capacity issues for my area. Do you think it would help a bit if I overclock my router, or is it time to bite the bullet and buy a new one, regardless of the capacity issues?

Yes. I have been informed that there might be some overhead with the PPPoE, but only supposed to be like 50mbps I think. The 200-300mbps seems like it is way too much. It is also definitely not the ISP, as other people I know get like 980ish Mbps with them.

They wanted me to set it to 1412, and I have nearly nothing enabled except for connmon and Diversion, and I don't think either of those would interfere. I also have IPv6 enabled. Weirdly enough, I actually managed to hit 1.3gbps on fast.com once or twice but had to set the connections to 30 and...

My ISP recommended it after I upgraded to a 1gbps line, my speed keeps being capped at 800-900mbps...

I need to set my MSS to a specific value. I know it can be set through iptables, but I also know that I don't know enough to mess with it. Any help will be appreciated.

This is the BCM470x - Cortex A7 ARMv7 revision 0 - Rev. c0 (Cores: 2) CPU variant. I have dabbled in overclocking it before, but I don't know how much it will help. Also, the memory might also be a bottleneck. Ah well, might just be time to get a better router. Any recs?

Hardware acceleration is enabled. The only other thing I run is the connmon.

Hi, I have an AC68U, and spdMerlin seems to bottleneck on 300mbps. Is this a hardware limitation? I get 500mbps+ when testing through WiFi...