Recent content by iManuB

Same situation, unfortunately. I had to put the 386.12_4 back on, because the devices with 5GHz couldn't connect: Pixel 6a and SkyQ. As soon as the 386.12_4 firmware was put back in, the devices reconnected immediately. P.S. With firmware 386.12_6, I had also tried to delete the wifi saved on...

Okay! You just need to remove the devices certificate. A thousand thanks! I thought that, after the update, it needed to be recreated. Forgive me!

Yes, following that guide (which always worked), I encountered this problem.

Hi! I did a hard reset and installed Diversion 5.0. I don't understand now how Entware works, because during the installation of Diversion you no longer have to enter the IP to assign to Entware. Yesterday I had problems generating the certificate, because at the command: openssl req -key...

Yep, sometimes... Thank you so much, Merlin. Have a nice day and a I wish a good job!

Weird! Should I try a reset and put the firmware back, or should I leave it like this?

Greetings! After upgrading to version 386.10 (with all the related Resets before and after Firmware installation) I noticed that QoS - WAN / LAN Bandwidth Monitor if "App Analysis" is not activated, it does not monitor anything. I don't see any movement. It's a normal thing? I never turned on...

Thanks for sharing, Wycleff. I appreciated that! 30 - MPU: 0 - Normal so far so good for me

Thank you so much, Alchemy. I really appreciate that! Very Kind! In waveform (gorgeous site), i've A+ Result. Dropped ACK Packets: 0 (Download and upload)!

Thanks a lot! I had already downloaded the GUI. Very comfortable! I connect to the TV via Wi-Fi. I leave 30 - MPU: 0, Mode: Normal?

Hello to the whole forum! I have a doubt about the value I should set on WAN packet overhead. I have an FTTC 200/20. My Asus RT-AC86U is connected to the modem (LAN 1 to WAN) provided by my ISP. On the modem provided by my ISP I have this: VDSL Training Status: Showtime...

Okay, thanks! Okay! I'll try! Thank you, Jack! I've been using CakeQoS since this morning and haven't seen a single dcd crash. For the moment, I'll leave it like this, since I manage to have bufferbloat A +

I have reset everything. Formatted the USB stick and installed Skynet+Diversion and FlexQoS. Aug 25 10:38:46 kernel: dcd[17491]: unhandled level 3 translation fault (11) at 0x00000000, esr 0x92000007 Aug 25 10:38:46 kernel: pgd = ffffffc011622000 Aug 25 10:38:46 kernel: [00000000]...

Gotcha!

I have the 200/20 connection, so I found that hardware acceleration is not needed for my connection. Kernel panic could also have been due to that. Once CakeQoS was installed, I no longer had KP. When 386.4 comes out I'll do a nice full reset and try Adaptive QoS again, without CakeQoS and I'll...