Recent content by Izze

Hi! FYI, I'm now using my old Lyra as a router (radio off) and hook up the AX92 ( wifi mesh to second AX92) in AP mode. Now everything works fine and i can block clients as expected and use the parental mode again. There is something with my clients that the AX92 router do not like. Hope a...

Well it is 40 (6 wired) clients on two AX92 in mesh. I.e. ~20 per each AX92 The CPUs run on only a couple of %, memory is running low though...not sure if it is related to my issues. It was working fine on my old Lyra and thought the powerful AX92 should be able to handle it as well?

It's around 40 clients, I will try someday when i get a few hours free!

.....and BTW i did see that the blocking was working when i only had a few clients connected. However somewhere when i added more it stopped working.

Thanks! I did a clean install not using any saved configuration. Entered all settings 'by hand'. All clients were rebooted with new SSID so not sure what else to do at the moment. Still good to know that it is working for others so it must be something peculiar with my setup...?

Ok thanks for the feedback and I did it, factory reset, latest firmware, new SSID (updated 38 wifi clients, ipads, android phones, Google assistant speakers, shelly and sonoff switches etc)....but still no luck. Not possible to block Wifi clients. I'm considering to put my old Lyra as router...

Yes, i might take that route...but it will take some time to update all clients connecting SSID that might fix the issue. Still a bit strange if the choice of SSID will decide if the blocking feature should work or not?

Thanks for asking! Well after the first factory reset i did create a "test SSID" where i added a few clients....everything was working fine where i could block clients. I did then change back to the 'original SSID' and then i got +25 clients on Wifi....then the blocking feature stopped working...

AndreiV, thanks! Did a factory reset but still the same issue. Blocking clients works fine if i only connect a few clients ....but i have +25 clients and somewhere the blocking feature stops working :-/ I did send feedback to ASUS via the web-interface...but no feedback so far.

Hi AndreiV and good to know that it should work! I'm thinking of doing a factory reset, update and set it up again and see if it resolves the issue. Thanks!

Hi! I have exactly the same issue as in the below thread...unable to block internet to clients....but i cannot find any newer firmware for my RT-AX92U that could fix it? Firmware version 3.0.0.4.384.9177...