Recent content by JoyceBabu

Is it possible to force switch back to primary WAN from secondary WAN manually?

Thank you. I have re-compiled the stock firmware from source and copied the curl binary. It is working fine.

I bought an Asus RT AC88U yesterday, on which I wish to run a custom script for DDNS updation. On my old RT-N18 I was using curl with the --interface option to update both my WAN ip addresses. I just found out that AsusWRT does not bundle curl with it. I do not want to void the warranty right...

Thank you.

I am using Asus RT-N18 running Tomato Shibby. I am thinking of upgrading to better router. I am considering RT-68U and RT-3100, which are not supported by shibby's firmware. I am considering installing Asuswrt on the new router. Can someone please tell me whether Asuswrt supports the following...

I was using DSL broadband until last month, and everything was working fine then. After that I replaced Tomato Shibby with Advance Tomato, and the issue started :(

192.168.1.251 is my cable modem.

I have an Asus RT N18 router with TomatoUSB installed. The router subnet is 192.168.0.0/24. I have a docker daemon running on a linux client (192.168.0.10). There is a docker network configured on the above client with subnet 10.10.0.0/24. WAN port is connected to a Cable modem in DHCP mode. I...

I would like to clarify that I meant 20 wirelessly connected devices, not VPN clients. There will be only at most one VPN client connected at a time. My issue is the low data transfer rate, while connecting through the VPN, which pretty much makes it unusable. I will install OpenVPN on a Core...

Thank you for the advice. Is CPU the major bottleneck when running a VPN inside a router? If so, would I see a noticeable performance improvement by moving the OpenVPN server to a Linux server, instead of running it on the router? If price is not the major consideration, then is it better to...

Thank you for your response. Are 20 connected clients too many to consider upgrading to AC3200? Or is it the number of simultaneously transmitting clients that matters?

I am planning to buy a new router for a small office. The total office area is 850 sqft, partitioned into three rooms. There will be around 20 connected devices. I wish to install TomatoUSB on the new router, and configure OpenVPN on it. The VPN won't be used heavily. It will be used only for...

My knowledge in networking is very limited. I am not sure if it is right to call it port forwarding. This is what I am trying to achieve. I want all HTTP and HTTPS traffic to pass through an intermediate server running Squid, so that I can perform DLP analysis on the data. I want to do this at...

I am changing the router because my current router does not allow me to transparently re-route all outgoing traffic on ports 80 and 443 through my firewall server. My current router allows port forwarding only for incoming traffic. If I understand correctly, custom firmwares allow me to...

Hi, I am planning to buy a new Wireless Router. The router will be used in a SOHO environment. There are 6 computers that work simultaneously, and it might increase up to 10. The firewall (stock firmware / custom firmware) should allow me to selectively block/open outgoing ports. It should also...