Recent content by jrhjr

Thanks for the response - I did not know this existed and am coming up on the internal limit so it'll be useful. While I have your attention - are you aware of any solutions to reserve/manually assign addresses on a AiMesh guest network sync'd to all nodes (so that dnsmasq/dhcp will distribute...

Is there a trick to using dnsmasq.conf.add? All I'm doing is putting dhcp-host lines into it... I've tried : chmod a+rx /jffs/configs/dnsmasq.conf.add nvram set jffs2_scripts=1 Even though this was already set in the web gui The lines I'd like get added to : /tmp/etc/dnsmasq.conf but the...

So I am still struggling with this problem - or rather these problems. #1 - Reboot loop I believe this person also had the problem. https://www.snbforums.com/threads/bug-ac86u-on-386-1_2-using-both-2-4-and-5ghz-guest.70824/ I am wondering if this is a separate problem - unrelated to my...

Question I have an RT-AC86U running Merlin 386.1_2 and I am wondering if anyone else is having problems or if there are any known problems relating to Wi-Fi when the guest network is enabled in slot #1 (leftmost) - particularly the 5G guest slot? I know that during the stock 386 beta testing...

Hi. So here's my question - can I initiate a factory reset on an Asus RT-AC68U running stock firmware via SSH? Backstory ... I have a four node AIMesh home network. The primary router is a Merlin AC86U, then two XT8s running stock and then the 68U (which was born a TM-AC1900 but is now running...

This worked for me, although my VPN client is on tun15 so I had to adjust accordingly. I was also pleasantly surprised that with this rule in place and VPN then disconnected - that it then sent the 10 traffic out the WAN successfully instead. I was concerned because when VPN drops the 192 NAT...

My apologies for not explaining the routing architecture well enough. The Velop router/firewall acts as a physical separator for the 10 / 192 networks. More specifically - the Velop firewall will drop inbound traffic from the 192 network were any devices actually on it. There is physical...

Thank you for the response. On my Velop router I did turn bridge mode off and then, so that Merlin would see the individual IPs on the opposite side of the Velop (the 10 side) - I turned NAT off on the Velop so it's actually truly routed (versus using NAT). So in theory Merlin should see the...

Hey I'm new - go easy on me! :) I've got an RT-AC86U running Merlin 384.18. It is connected to NordVPN via OpenVPN with strict policy rules making it so my whole network goes through the VPN - sorta... And therein lies the problem. My main network is 192.168.1.0/24 and everything in that...