Recent content by JulienG

xd5 or xd4 as nodes with RT-AX88U Pro as primary router. What do you think about this config ? Thanks

Hello, All my AI Mesh nodes are connected to an ethernet switch. This switch is connected to my primary router. I am in the below configuration. Should I set "Ethernet Backhaul" to Yes in my AI Mesh configuration ? Thanks

Hello, I have the following configuration in our 4 floors house - 1x rt-ac88u on l1 which is the primary router - 3x Lyra mini configured as ai mesh nodes (1 per floor l2 l2 l4). They are all on a wired Ethernet backhaul (basically doing access point work) The Lyra mini are not very stable and...

Morning - I am still hesitating between the EAP225 Wall (nice but difficult to fit) and EAP225 Outdoor (less nice for indoor usage). I have noticed that EAP225 Wall has 2 Ethernet ports on the bottom indicated as OUT (while the IN one is at bottom-. By any chance, do you know if I could...

Eap 225 outdoor fits with the budget and installation should be ok. Thanks a lot for this reco. Is there a controller required for eap 225 ? last question: I will need a Poe switch with a least 3 ports. Can I add this switch on top of my existing 24+ ports switch ? What do you recommend me ...

Here is a picture of my plugs to be very precise. What would be the best option to mount eap 225 wall ? I take a short wire from the existing plug but I need to bring it to the back of the ap...

I have one wire going from the switch to the current junction box with rj45 female plug. There is no space to add a second network wire in the sheath. So I would need to remove the female plug, put a male plug instead and add anew hole for a 1 gang junction box. Am I right ?

What about D-Link COVR-1103 in wired AP mode?

The challenge is to transform a 2 or 3 Gang junction box into a single... AC-LITE will not work as I don't have shelves or armoires closed to the ethernet plug :-( Tricky to find a good, not too expensive solution. What about other brand ?

Thanks @Trip ! In-Wall : it would be perfect in terms of price but I have double or trip plug like this for all my network plug. I don't know if some mount exist so that I can plug it on the existing ethernet wall plug. FlexHD: the format is perfect and easy to fit on a wall but it is very...

I have: - D-Link Dir 868 (2015) - Airport Extreme (very old not even AC) - Netgear R6220 (2018 but not very stable) All of them are configured in AP mode.

My experience is that signal does go across floors (vertical) My RT-AC88U is installed in first floor the house and his signal is very bad on second floor. So I found that the best way is to have access point wired on each floor. Each floor is not very large and easy to cover horizontally (no...

Any idea for this ? Thanks a lot.

Hello - I have a house with 4 floors which is fully ethernet wired. L1 is covered by a Asus RT-AC88U router connected to 400 Mbit/s fiber internet connection; I want to buy 3 wired access points to covered each level L2 / L3 / L4 (around 50 square meter each). Today I am using 3 old router in...

I will check the LAN first. I suspect Laptop B has a bad performance wifi card.