Recent content by LeeH

Load balancing improves performance in my testing but happy to dump it. I can get you whatever information you need, will post up the my IP's (most of it) tomorrow as my ISP changes tomorrow.

Should be no issue, latency us under 50ms and a good 100/30 connection at least. I have no idea where it is coming from but it must be an issue with the Zyxel NR7071 which is in bridge mode as when I make the FTTC the default, turn off load balancing (LTE off) the NAT shows moderate. Which...

Hi Tech9, What’s not working? It is impossible to online game with a double NAT. Moderate is not preferable. My FTTC connection is 10/1 at best hence why I have the LTE router on the side of my house. with this I get up to 200/40. 100/30 on average.

Hi Tech Junky, I have no idea on how to to the above unfortunately. If you could point me the the right direction that would be great. I do have a Surf shark VPN account...

Screen grab if it helps.

Hi All, Could anybody help me with my double NAT issue. This is the first time I've connected my xbox to my current set up, had no issues a year ago with the standard ISP router. I have 2 connections now, FTTC (OneStream) and LTE+ (EE) Set up below. If I turn off the LTE I get a moderate...

Hi, My 214 play with WD red drives is 7 years old now. Yep m looking to replace it with another Synology as I have 10 camera licences invested into it. It’s becoming a little slow and requires rebooting periodically. I mainly use it for surveillance, photos, docs and the odd movie that’s...

And it's broke again....

Factory reset fixed it.

Well, I have the VPN working on my synology NAS so it seems like a problem with the router. Im going to restore it back to factory and flash it again with Merlin. See what happens...

The general log might as well be in Chinese so i presume it will say 'error'? FYI I can ping my self from the router...

I enabled 'Enable Ping' and ran it again. Makes no semse to me.... Oh, thanks for your time!!!

Hmmm, I just did cmd/ping/my ip and nothing.

My firm ware says powered by Merlin 380.57. It's 100% Merlin as I need option 61 to connect to my ISP. The stock firmware does not allow me to connect and my ISP forbids any 3rd party router use. I had to extract my username and password using Wireshark. I'm at work at the moment...

I'll do that now thanks. I found 2 suggestion while googling. One was to make the DNS static which I have, I used Googles 8.8.8.8 and 8.8.4.4. And to open this port but there is no suggestion where to direct it too. Also the idea is to close my ports tom access all my IP cams. Not to open more.