What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Leguar

  1. Leguar

    Upgrading my TS-251 Pro with latest FW ends in errors ...,

    After 24+ hours I tried again to install the new FW. This time without any problems, therefore I'm up running again :) But thinking back.... I have always problems with new FW's into my TS-253 Pro (80%), where as my TS-251+ have no problems (1%) - (ok, one time it went wrong).
  2. Leguar

    Upgrading my TS-251 Pro with latest FW ends in errors ...,

    Upgrading with the new TS-x53 20241025-5.2.1.2930 firmware ... Hope for some help, upgrading my QNAS 253 Pro, from v. TS-x53 20240817-5.2.0.2860 to the new TS-x53 20241025-5.2.1.2930. The upgrade ends with lots of beeps (nearly in any combinations). Have tried several times to do it over and...
    • Leguar
    • Thread
    • Replies: 2
    • Forum: QNAP
  3. Leguar

    Hot Swapping 2 bigger HDD's into my TS-251+ Raid-1 ...

    @ L&LD Here's the link: https://forum.qnap.com/viewtopic.php?t=173835 Dont know if the link is working.
  4. Leguar

    Hot Swapping 2 bigger HDD's into my TS-251+ Raid-1 ...

    Thanks to sfx2000 and dosborne :) @dosborne You're right, and the poster over there had the right answer, so I'm up 'n running, with my two new HDD's. Thanks again :)
  5. Leguar

    Hot Swapping 2 bigger HDD's into my TS-251+ Raid-1 ...

    Are now changing from 10TB to 16TB HDD's, but it seems that I have a problem now, because the UI have changed since last time I did it. QNAP TS-251+ with v. 5.1.5.2679. I have one by one swapped the two HDD's without any problems (ok.... it took nearly 48 hours), but that was not a problem. As...
    • Leguar
    • Thread
    • Replies: 10
    • Forum: QNAP
  6. Leguar

    A Green Ringing Bell ...

    Thanks but I did that. The cursor changed from an arrow to a hand, but no explanation. So that's why I asked :)
  7. Leguar

    A Green Ringing Bell ...

    RT-AX88U with Merlin's latest firmware. Have problems getting to the internet from the router through my fiber modem. Is that what the "little green ringing bell" tells me ???
  8. Leguar

    Feature Request: allow to see offline clients

    The app is named "ASUS Router" (android) and is a nice gem to overlook your LAN and devices.
  9. Leguar

    VPN Client: Is Merlin's kill switch killing too much ...

    @Hazel Naturally I look at it from MY thinkings ;-)
  10. Leguar

    VPN Client: Is Merlin's kill switch killing too much ...

    Make sense, but still disagree, 'cause a personal action, aka. close a VPN tunnel should override a kill switch :-)
  11. Leguar

    VPN Client: Is Merlin's kill switch killing too much ...

    Replying to my own msg. about testing this later. 1) VPN tunnel is On - want to turn it Off 2) Setting "Block routed clients if tunnel goes down" to No - and apply setting. 3) Turn VPN tunnel Off Result: Still no connection from Lan til Internet. And have to reboot the router.
  12. Leguar

    VPN Client: Is Merlin's kill switch killing too much ...

    Oh my. This could be an alternative, though I still think if I decide to close the service, should overrule the kill switch. Will test this later :-)
  13. Leguar

    VPN Client: Is Merlin's kill switch killing too much ...

    RT-AX88U Merlin v. 386.2_4 As you can see, I have a VPN Client running. Service state is ON (picture 1 and 2). Now and then I have to close the tunnel, and go back to my normal Lan. If I disable the Service state (OFF), my whole Lan goes down and I have to reboot the router to get connected to...
  14. Leguar

    Solved Import an .ovpn file into RT-AX88U (Merlin 386.2.4) ...

    Thanks Colin Taylor, After your instructions, I have now established a VPN connection from my router and out. Tested with Udp and Tcp. Thank you so much :-)
  15. Leguar

    Solved Import an .ovpn file into RT-AX88U (Merlin 386.2.4) ...

    OMG :-) Thought I did "mask" all addresses. Well obviously not :-(
See more
Back
Top
✖