Recent content by mbze430

Celestica DX010 running Microsoft SONiC.

Access points are extension of a VLAN, each SSID can belong to a different VLAN. The layer 3 switch ends up routing to each VLAN interface (SVI). I never had issues with routing. I had issues trying to use the AX88U-Pro to extend my WLAN for more coverage. @coxhaus if you knew about the...

I found a way to do it with single wire. But your switch needs to support PVID and/or General mode. Most Cisco switch support it, but not sure about the others. Set the AX88Pro as All(Default). Create all your VLANs On the switch that support PVID and/or General Mode. console# sh run int gi...

I was able to get it to work. Used two cables, since the ASUS firmware won't allow you to assign a VLAN to the 'default' LAN/WIFI. Have to use one of the port to pass all/any traffic; passing LAN and main wifi. Then setup another port as Trunk and pass all tagged packets simplified: AX88ProU...

I own a RT-AX88U Pro and recently update the firmware and wanted to use the VLAN feature. Normally with any SMB AP product, it is a slam dunk easy config. But I am not sure about these ASUS consumer APs. Here is the topology of my network (simplified) Questions: 1) In AP mode, under the...

I am going to assuming this requires CLI as I don't think the GUI is able to do this. I need to be able to configure one of the 10Gb port as a routing port. I am completely NOT familiar with the ASUS CLI syntax. My current set is as follow in the diagram, but it's not quite working as expected...

Unfortunately, the BETA VLAN v9 firmware doesn't have any of that. I can only create a VLAN here: LAN -> VLAN -> Profile All I can do is definte a VLAN ID and a spot to checkmark for Port Isolation. On the VLAN Tab, I can set each port to either All(Default), Access, or Trunk In Access Mode...

There is no 3.0.06.xxxx for this router... only the 9.0.0.xxxx and yes it hasn't been updated for an entire year while the newer BE router has the 3.0.06.... am I SOL?

just trying to put one of the 10Gb port in Trunk mode. But it's not passing traffic. Anyone know if the ASUS use Native VLAN? As soon as I set either side Trunk All Vlan it just drops my main VLAN is 1000 and I have bunch of others. the other side is a Brocade VDX 6740 10GB...

Apparently this issue still exist as of July 2023. There is another thread about this and the end result was getting in via SSH and then reconfiguring the firewall. I don't understand why ASUS would let this "bug" go as-is. I am on 388.2_2 Merlin

are these firmware base on the AIMesh 2.0?

Is it me or I don't see Beta 4 on the AX88U as of 1/17 @ 1:20PM CST https://ibb.co/VVdqrS8

I have a AX88U and I wanted to find out if interface bond0 is the WAN Aggregation or it's the LAN LACP? I have both enabled and didn't want to bring down any links to see which is what.

dirty upgrade from Beta 2 which was a fresh install REboot doesn't do anything it was working fine prior to the Beta 3. JFFS is not full nor corrupted

what does it mean if my uiDivStat is missing the top Top Block Domains and top requested domains? running merlin 386.1 beta3