Recent content by RickGW

Already done that multiple times. As soon as I change something in the WiFi settings, the error disappears, but it always comes back after a while.

Re-adding the node didn't help. Although the errors went away for a while after my last changes in the WiFi settings, now they are back: Jun 13 07:18:22 acsd: acs_init_run(1111): acs_start eth7 cannot select chanspec with the wrong info Jun 13 07:18:25 acsd: eth7: Selecting 5g band ACS policy...

Yes, both are purchased in the same country, I will try to re-add the node!

Done, the errors are gone for now, but I also did this a couple of days ago and the errors came back after a while, so they will probably come back this time as well.

Unfortunately not, I did this a couple of times in the beginning when I first saw these errors. They always come back after a certain amount of time.

Because of these repeated logs every 3 seconds, I cannot scroll back to other logs anymore :(

So it was all good for two days and today out of nowhere the error messages are back:

Yes, it was fixed on channel 6 and the bandwith was 20/40 MHz. Changed it to channel 1 and 20 MHz only and now the errors disappear! Let's see if it stays this way.

I didn't try a factory reset yet, as it seems a lot of work when starting fresh over with all my settings for PPPoE, static IP addresses, WireGuard VPN server and clients (Fusion). So if nothing helps, I can always try that. I did start fresh over when upgrading from my old AC86U, so no...

Thanks for your reply! But I already have a fixed 5 GHz channel, or do you see something else?

The last couple of weeks I get persistent error messages on my Asus RT-AX86U. I noticed them because my Synology NAS (where I store all logging) keeps writing like crazy and I hear the drives continuously. The errors are like this and it goes on forever. I googled the error, some advice came...

Thanks for all replies! With the new official 3.0.0.4.388.22068 firmware the problem seems gone! I get full 1 Gbps from clients outside the VPN and 400-500 Mbps from clients inside. So in the end it didn't seem hardware related.

Anyone else experiencing some strange things with WireGuard? I finally got it to work, so it seems, but in the Asus GUI it still shows disconnected. But the WireGuard app on my clients shows incoming and outgoing traffic. What's up with that?

Well I’ve got the WireGuard server running in Docker, and my iPhone seems to connect, but I cannot access websites. Maybe a DNS conflict issue with AdGuard, also running on the Synology… must do some digging, will report back.

Just found the same page, haha! Thanks.