Recent content by Salty Wagyu

Thank you, seems to be working in wan-start now /jffs/scripts/ChkWAN.sh cron="\*/5 \* \* \* \*"

Logs are working again in the UI, only had to press the clear button to fix it. Wouldn't have thought to try that but it worked If anyone knows about the cron issue I would appreciate some assistance with that!

I installed using curl --retry 3 "https://raw.githubusercontent.com/MartineauUK/Chk-WAN/master/ChkWAN.sh" -o "/jffs/scripts/ChkWAN.sh" && chmod 755 "/jffs/scripts/ChkWAN.sh" Then nano /jffs/scripts/wan-start added: sh /jffs/scripts/ChkWAN.sh & then chmodded 755 wan-start It was working but I...

Thanks for looking into it! That's a shame, I will have to see if I can get a script running to force reboot it should it happen again, ChkWAN might do the job

Sure, here's the previous 12 hours before everything stopped working: https://pastebin.com/AUf7Pzmp I have an uptime service running on a linux box that pings the router every 30 seconds, the logs say it became unreachable at 23:04:12

So it's happened again after two months... pings or webui access (by IP address) to the router & modem via ethernet was unreachable. Mobile devices could not reconnect to the router after manually disabling/enabling WiFi in Windows/Android, and lights on the router were flashing normally. I...

here we go: https://pastebin.com/Zye8GxJu

The internet was inaccessible between 7.10 and 7.43pm (the point I switched router off then on). During the downtime I was unable to connect to the router's web interface nor the modem's web interface. Android phone saw my active 2.4 & 5GHz networks but refused to connect to them (normally it...

I lost DSL sync a few times last night so I tried to connect my OnePlus 8T phone to the AX-86U and enabling 3G/4G and USB tethering without any luck in getting it working. Fast forward to today, I unplugged the DSL cable from the router to test this further and try out things to get it working...

Thank you, all up and running now!

How long should "Creating database table indexes..." be taking in Putty during Connmon installation? It's been going for about 10 minutes, the webpage for it seems to be working at least but can't run a ping test.

What's the best way to know what changes I've made from defaults since I aquired the router? 384-4 recommends a factory reset and setting everything up manually, so I downloaded the backup cfg but it appears to be all in binary when opened in Notepad.