Recent content by Sg1

Yes AC88U turned off guest network no joy..... actually the recording on the nas its no good it records but keeps interrupting. Factory reset of the router is the only option I giuess

Tried most of the channels same story but sometimes I get the connection back for 15-20 minutes and then it goes again only on these two cameras. Tried also both static and DHCP same story. Tried to change port from 81 to 8100 no joy. Also one of the cameras is recording fine on the USB drive...

no open networks around, all secured networks.... IP address on the header is from my ISP (which I also use the smtp server to send emails). Doesn't make any sense what is happening. See log where the two camera show up .19 and .20

I tried that already, move the frequency 20/40 channel, b/g protection etc no joy..... never seen something like this.... :) only the two devices from the same mfg are having a problem. Even more strange is that cameras do not show up in network map but they show up in connections logs, you...

Hi Have two cameras (ucam247) and suddenly I am having connections problems with both camera. They connect via wifi 2.4 ghz. Can't ping them.. They do not appear in the network map however they appear in the wireless log (flag _S__AU_). Running them for years no issue. Didn't change any...

Hi I Enabled IPV6 in the router ( ac87u). I called the ISP and they said they support IPV6. I have a cisco modem 3925 connected to the ac87u in bridge mode. I assume as long the provider supports IPv6 the cisco doesn't have anything to do with IPV6. I use DHPC from the ISP, I rebooted...

Are this errors normal? I have a lot of them in the log... Running latest Merlin. AC87U. Sep 28 14:35:48 dnsmasq-dhcp[18391]: DHCPACK(br0) 192.168.1.4 00:06:dc:82:20:65 Sep 28 14:36:05 kernel: Dead loop on virtual device vlan2, fix it urgently! Sep 28 14:36:05 kernel: Dead loop on...

It seems quite high with nothing happening. Also if you disable the 5GHZ radio, why doesn't show 0 as temperature? it looks like that even though it is disabled still high.

Hi Running Merlin 3.0.0.4.376.47_beta1 the CPU temperature seems quite high http://192.168.1.1/Tools_Sysinfo.asp 2.4 GHz: 47°C - 5 GHz: 57°C - CPU: 76°C Router is doing almost nothing. 5-10% load. Also 5GHZ is disabled why temperature is still high? Something wrong...