Recent content by szimat

Well, there are some adblocking ways that already managed to prevent this message. Hopefully it can be done with Diversion too.

Hi! Using Diversion, works fine. But recently there are lot of pages where at the bottom of the page a warning is fixed that I'm using adblocking. Quite annoying, especially on phone. Using Chrome most of the time. Any way to avoid this? Thanks!

I'm having also WiFi droppouts since about a week or so. Had been running fine for around two years. I was on 386.5_2 until yesterday. Upgraded to latest yesterday (386.7) to see if this helps. Running two AC66U B1 routers, one being Aimesh node (with wired gigabit backhoul). 5 GHz is perfectly...

This is the settings now. Can I try to use Pihole DNS (192.168.1.10) instead of CF?

I have switched to Pihole, running Merling on AC66U_B1. I use cloudflared on Pihole as upstream DNS to get DoH. In Asus LAN DNS I have set the DNS server to the Pihole address. And I have DNS Filtering enabled for Pihole (set to No Filtering) -> this is the only way to have Pihole working. And...

Ok, so I upgraded the node's fw to latest Merlin. The Aimesh network seams more stable now, didn't have (yet) any glitchea. And the signal and speeds are great in the whole are needed to be covered. I have full and strong 5 GHz coverage everywhere where needed. Did some settings according to the...

Well, first day like this. Had some connection losts, like a dropout for short time. I will upgrade to Merlin on node router too.

I have two RT-N66U B1 rourers. Main router running latest Merlin stable. I added the second router as Aimesh node (over wifi, not possible to use cable), running latest stock fw from Asus. Question: should I use latest Merlin on the node router too? I read here somewhere that it is better to...

A little too complicated to my knowledge: I have severacl docker containers running on my server. Isnit possible to route one container over VPN (with killswitch).

Great script. Just to be sure: if I install this script, do I need to run it always or it will show me real time stats in UI, once it is installed?

I see it has been asked many times, but I couldn't find a final answer. I used Pihole until now, but I would give Diversion a try. Have a Sandisk Ultrafit USB 3.1 32GB. The router is Ac66u B1 running latest Merlin. Maybe even add Skynet. 1) I guess I should use the USB 2 port and not the USB 3...

Use Wireguard on your phone. The downside is that you can't run it on Merlin fw, but if you can run WG on a server or Rpi, etc, than just set configure, download the official app (I only use Android) and usr it always when you are out of hine wifi. It drains literarry a minimum battery and...

I replaced my N66 running John's latest "official" fw with Ac66u b1 (running latest Merlin). I would like to use my N66 as wireless repeater, but it doesn't seem to work. Can't find any ssid, just hangs on scanning. How can I revert back from John's fork to latest official Asus fw? Just flash...

Hm, the 66U B1 is newer than AC86U? I didn't know that. Well, if I understand it correctly, the AC66U B1 is better?

To not start a new thread. I have a Dark Knight now, running John's fork, but would like to be able to use Merlin. I can get as used AC66 B1 or AC68U. Later is more expensive. Is there any reason to get the AC68, is it better in any way? I will use Diversion and Skynet, nothing else, maybe...