Recent content by thegr8anand

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
  1. T

    Custom firmware build for R7800 v. 1.0.2.74.4SF

    No lost settings for me either.
  2. T

    Custom firmware build for R7800 v. 1.0.2.74.4SF

    Never bothered with it and a few times i checked on xbox live settings it used to fail then on fixing it strict. I set nat to open on r7800 but it only changed to moderate. Was unable to change the nat settings on isp router as it didn't allow bridge mode and disabling nat stopped internet to...
  3. T

    Custom firmware build for R7800 v. 1.0.2.74.4SF

    Why is open nat good for gaming? How do you change that?
  4. T

    R7800 and 160mhz setup

    A simple question but tbh haven't found a simple answer to how to set it up properly. 1 - So once i enable HT160 in advanced settings i need to select a DFS channel to use a contiguous 160 and not 80+80? 2 - Do i need to disable Mu-Mimo when using HT160 mode? 3 - How do i test if its working as...
  5. T

    Nighthawk X4S - QoS Device Priority keeps changing

    Yeah, I'd prefer to use it with almost 10 devices connected at once so gaming pc gets priority.
  6. T

    Nighthawk X4S - QoS Device Priority keeps changing

    This has been an issue ever since i got X4S be it stock firmware or Voxel's. You would think with the MAC address the setting would stick but it keeps changing from whatever priority i set. Any solutions?
  7. T

    Urgent help need R7800

    Its running fine since upgrading to netgear .62 firmware and hopefully it won't happen again. And won't be using scheduled reboots.
  8. T

    Urgent help need R7800

    After another reset i upgraded the firmware to netgear .62 and was able to set it up and running for now. I think the problem is occurring when power loss happens (switch off/electricity down) and then i have to hard reset and set up again. I am avoiding to test this by turning the switch off...
  9. T

    Urgent help need R7800

    Hi guys, Have been using Voxel .62 firmware and i had set it to reboot everyday 5am using kamoj's commands. Today when i woke my wifi was not working and on seeing the power led was amber (just permanent on, not blinking). I did factory resest and set it up again but everytime i reboot it...
  10. T

    Custom firmware build for R7800 v. 1.0.2.61SF

    Issue not specific to Voxel i think but why do the priority in attached devices keep reverting to default every restart? I have only used voxel firmware since i got this. Is the priority saved based on ip instead of mac address? Will be upgrading to .62sf now.
  11. T

    [Solved] Scheduled reboots and other log related questions

    Worked for me and rebooted at 5am. Thanks kamoj.
  12. T

    [Solved] Scheduled reboots and other log related questions

    Hi, I have no knowledge of cron but have logged in using putty and telnet to the router. Tried to enter the commands from this post. error on 3rd command. What am i doing wrong? I want to reboot the router everyday at 5am.
Top