Recent content by Theo Gjaltema

Recently after replacing the rt7800 bij a cheap switch. The network became terrible unstable hereafter. This switch was not capable of igmp snooping and probably a tv which was turned off and put it's interface to 10 mb/s. This caused the switch to overflow, which caused a wifi extender also...

I had similar problems with Netgear nighthawk used as primary router after switching ISP. Statistics in the Nighthawk showed traffic load on all inner network lines and wifi way higher than incoming by ISP. Since our problems always seemed to start when watching tv I assumed that multicast...

A few months ago I switched from Ziggo to KPN, exchanged the Ziggo router to KPN-box12b and thought I could continue with business as usual. This was not the case. The intern network failed, the Netgear R7800 router statistics came with (internaly) transmissions of total 3.5 Gb/s (external to...

I am wondering: why are there two different versions of OpenSSL present/needed? Works great anyway! Regards

Since disabeling QOS solved this problem I also disabled the WMM for both 2.4 and 5b GHz. This had the nasty sideeffect that wifi throughput dropped to 22 Mb/sec (measured with speedtest on a One+7) After complains from my kids I re-enabled the WMM and the thougput restored to previous levels...

I found a work-around. In the router I disabled Dynamic-QOS, no problems anymore! Previous (with Dyn.-QoS enabled) there were multiple hick-ups every hour, now during a test period of at least 10 hours it didn't happen again! Since the disk nor file-system type didn't make a difference I...

Did the test with an ssd of 250G connected to the USB. Stil not flawless. I have now turned off Qos. See what happens.

As a followup: Already tried the following: 1. Replaced all cabling&swith by a new cable without swith, no result (so I rule out the bad cable & bad switch option) 2. Replaced the WD 4TB -ext4 formatted disk by a WD 3TB ext-2 formated disk , looks like some improvement but still annoying pauses...

Hi, I have a R7800 running voxel V1.0.2-81SF firmware. Since my nas crashed I connected a disk formatted ext-4 to the USB of the router and configured ReadyShare to export it to my local network. When wathing movies stored on this disk I often get time-outs of multiple seconds. The devices I...

I owned a smalle one bay NAS. The rt7800 equipped with Voxel firmware outperformed this so I even dropped the NAS. Just connected the drive to the router.