eth0
-
M
Nighthawk R9000 Eth1 and Eth2 interfaces
Hi All, I'm trying to identify which ports in the back of the R9000 are eth1 and eth2 respectively, I know all are in the same switch but I want to break apart the switch and use those eth1 and eth2 independently, each has its own MAC address. Any ideas where do I need to look into the Voxel's...- multicast
- Thread
- eth0 eth1 eth2 netgear r9000 nighthawk r9000 switch configuration voxel
- Replies: 5
- Forum: NETGEAR AC Wireless (Wi-Fi 5)
-
Completely resetting WAN interface
I am looking for commands to completely reset the WAN eth0 interface on my RT-AX88U equivalent to what happens during a reboot. Something that goes beyond service restart_wan. Background: my WAN goes sporadically down and only a reboot fixes it. I would like to find a way to take eth0 offline...- Kanji-San
- Thread
- eth0 internet down reset sporadic wan
- Replies: 18
- Forum: Asuswrt-Merlin
-
O
Setting IP addresses for two interfaces on the same physical port
Hello everyone! I recently bought a RT-AC66U, and instead of using firmware that I'm familiar with, like stock or Open/DD-WRT, I decided to try Merlin on it. So far it seems awesome, everything runs great and I'm happy with all its features. However, I ran into a problem when I tried to set...- OzTm
- Thread
- eth0
- Replies: 6
- Forum: Asuswrt-Merlin
-
D
Has vlan2 been replaced with eth0 ?
In previous Asuswrt-Merlin firmware, the wanface on an RT-AC88U was called vlan2, but in the most recent beta, it's called eth0. Is this a typo or a permanent change ?- Denna
- Thread
- eth0
- Replies: 4
- Forum: Asuswrt-Merlin
-
EdgeRouter POE Setup
I am using an Ubiquiti EdgeRouter POE configured using the included WAN+2LAN wizard as follows : Eth0 - Unused Eth1 - Comcast Internet Eth2 - PC#1 Eth3 - Actiontec MOCA Adapter Eth4 - PC#2 Eth2-4 use the samee DHCP server (192.168.2.2-254). Is there any way to configure Eth0 to make it part...