Hi,
I installed my two ECB6200 bonded adapters last week and from the tests I've been running with iperf I get ~500Mbps.
I live in an apartment and I have installed a MoCA filter in the main building splitter where the main coax comes in (from the street) and the cables go out to each apartment (installed the filter only for my coax of course).
I have two outlets in the apartment.
The setup looks like this:
Outlet 1->Cable modem->ECB6200->Asus RT-AC68U
Outlet 2->ECB6200->Netgear Gigabit switch
iperf test was run with wired devices (on one end to the RT68U and on the other to the Gigabit switch).
From the reviews and tests I've read, I was expecting 700-800 Mbps, but it seems that I'm stuck at 500.
Is there anything I should check ot that I can do to improve it?
Thank you in advance for your advice.
I installed my two ECB6200 bonded adapters last week and from the tests I've been running with iperf I get ~500Mbps.
I live in an apartment and I have installed a MoCA filter in the main building splitter where the main coax comes in (from the street) and the cables go out to each apartment (installed the filter only for my coax of course).
I have two outlets in the apartment.
The setup looks like this:
Outlet 1->Cable modem->ECB6200->Asus RT-AC68U
Outlet 2->ECB6200->Netgear Gigabit switch
iperf test was run with wired devices (on one end to the RT68U and on the other to the Gigabit switch).
From the reviews and tests I've read, I was expecting 700-800 Mbps, but it seems that I'm stuck at 500.
Is there anything I should check ot that I can do to improve it?
Thank you in advance for your advice.