Release Asuswrt-Merlin 3006.102.7 is now available

[CaptnDanLKW]

Did anything change in busybox? Its missing some of the common commands like

w
whoami

maybe others?

 

[dave14305]

Did anything change in busybox? Its missing some of the common commands like

w
whoami

maybe others?

Are you sure they were ever there?

 

[ColinTaylor]

Did anything change in busybox? Its missing some of the common commands like

w
whoami

maybe others?

There's no indication that they were ever included in the base firmware. You must have got them from Entware.

 

[CaptnDanLKW]

Are you sure they were ever there?

So, I absolutely sure they were there. For years, and from muscle memory, I would 'w' as my first command when logging in as habit. It showed uptime and my active session.

In short, @ColinTaylor was right (as he always is)

I guess when I did my last fresh install a few months back, I took a more minimal approach and only have what my addons pull down for dependences, and previously at some point in the past I must have installed core-utils and that was the norm for years.

Thanks

 

[Garden Dwarf]

Hi,
Since around 1:00 AM this morning, my Asus RT-BE88U has been showing a "Disconnected" status for the internet connection (ISP: Orange Belgium). This may have started right after the firmware update. A power cycle did not resolve the issue.
To narrow down the problem, I temporarily disabled bridge mode on the ISP modem (through a factory reset) and bypassed the Asus router entirely - the internet connection worked fine through the ISP modem alone. I then re-enabled bridge mode and reconnected the Asus router, but the issue immediately returned.
This points to the router being the likely culprit. I'm planning to downgrade the firmware tonight when I get back from work.
In the meantime, if you have any diagnostic steps or potential fixes to suggest, I'd be happy to try them.
Thanks!

 

[visortgw]

Hi,
Since around 1:00 AM this morning, my Asus RT-BE88U has been showing a "Disconnected" status for the internet connection (ISP: Orange Belgium). This may have started right after the firmware update. A power cycle did not resolve the issue.
To narrow down the problem, I temporarily disabled bridge mode on the ISP modem (through a factory reset) and bypassed the Asus router entirely - the internet connection worked fine through the ISP modem alone. I then re-enabled bridge mode and reconnected the Asus router, but the issue immediately returned.
This points to the router being the likely culprit. I'm planning to downgrade the firmware tonight when I get back from work.
In the meantime, if you have any diagnostic steps or potential fixes to suggest, I'd be happy to try them.
Thanks!

Try powering both modem and router off. Power on modem, and power on router 15 seconds later.

 

[Garden Dwarf]

Try powering both modem and router off. Power on modem, and power on router 15 seconds later.

Well, no luck... I still have the issue.

 

[BOFH]

My wifi security cameras are still dropping out and other devices for 3006_102.7 & 3006_102.6.

It happens on both GT-BE98 Pro & RT-BE88U

I've gone back to 3006_102.5 which is stable, no drops outs at all.

Same as me but only for the devices connected with Wifi 6. Same place, same everything but with the new firmware they got disconnected

 

[maxbraketorque]

Installed and running without issue on my AX86U Pro and GT-AX6000 main/AP combos this weekend.

One unusual thing that happened was that after installing it on my AX86U Pro main router and rebooting, CPU3 or CPU4 went into heavy usage for about 1-2 minutes, and during this period the router kicked me out of the GUI a few times.

 

[Poul Bak]

One unusual thing that happened was that after installing it on my AX86U Pro main router and rebooting, CPU3 or CPU4 went into heavy usage for about 1-2 minutes, and during this period the router kicked me out of the GUI a few times.

That is quite common after a firmware update and should be 'respected' - meaning let it run for about half an hour, then (after the CPU has settled down) perform a reboot and you're good to go.

 

[gabox]

Hi,
Since around 1:00 AM this morning, my Asus RT-BE88U has been showing a "Disconnected" status for the internet connection (ISP: Orange Belgium). This may have started right after the firmware update. A power cycle did not resolve the issue.
To narrow down the problem, I temporarily disabled bridge mode on the ISP modem (through a factory reset) and bypassed the Asus router entirely - the internet connection worked fine through the ISP modem alone. I then re-enabled bridge mode and reconnected the Asus router, but the issue immediately returned.
This points to the router being the likely culprit. I'm planning to downgrade the firmware tonight when I get back from work.
In the meantime, if you have any diagnostic steps or potential fixes to suggest, I'd be happy to try them.
Thanks!

Try factory reset in your router.tks

 

[heysoundude]

That is quite common after a firmware update and should be 'respected' - meaning let it run for about half an hour, then (after the CPU has settled down) perform a reboot and you're good to go.

I’m lucky enough to work into the wee hours on weekends, and get home when the rest of the house is sleeping and the network is quiet. This is when I tend to do updates/upgrades, to avoid disturbing things. I update, then go to bed. If I’m awoken with coffee, I know something is awry, but somehow I always make my own coffee.

 

[robinjoo1]

i keep getting this error but all the trend micro bs is shut off
ar 7 00:29:59 networkmap: Error locking /var/lock//usr/networkmap/nmp_conv_type.js.lock: 2 No such file or directory
Mar 7 00:29:59 networkmap: Error unlocking -1: 9 Bad file descriptor
Mar 7 00:29:59 networkmap: Error locking /var/lock//usr/networkmap/nmp_vendor_type.js.lock: 2 No such file or directory
Mar 7 00:29:59 networkmap: Error unlocking -1: 9 Bad file descriptor
Mar 7 00:29:59 networkmap: Error locking /var/lock//usr/networkmap/nmp_bwdpi_type.js.lock: 2 No such file or directory
Mar 7 00:29:59 networkmap: Error unlocking -1: 9 Bad file descriptor
Mar 7 00:29:59 networkmap: start scan...

 

[bennor]

i keep getting this error but all the trend micro bs is shut off

In addition to turning off Trend Micro did you also Withdraw from Trend Micro/AiProtection on the Administration > Privacy (or Policy) page?