Hi!
I’m running a single AX6000 on the latest firmware (3.0.0.6.102_21514).
Unfortunately, DDNS isn’t working, ie. it’s not updating after a WAN IP change.
I have a NO-IP account properly configured and it updates normally when I manually confirm/apply the settings in the DDNS tab of WAN page.
Here’s the log output when IP changes:
No DDNS entries in log and when I log into NO-IP dashboard, the old IP is still shown.
What the hell is going on?
I thought I had an issue with ASUS DDNS service, but this seems like a firmware/router issue.
Please advise.
I’m running a single AX6000 on the latest firmware (3.0.0.6.102_21514).
Unfortunately, DDNS isn’t working, ie. it’s not updating after a WAN IP change.
I have a NO-IP account properly configured and it updates normally when I manually confirm/apply the settings in the DDNS tab of WAN page.
Here’s the log output when IP changes:
Code:
Jul 19 16:28:14 wan: finish adding multi routes
Jul 19 16:28:14 rc_service: udhcpc_wan 4209:notify_rc stop_samba
Jul 19 16:28:14 rc_service: udhcpc_wan 4209:notify_rc start_samba
Jul 19 16:28:14 rc_service: waitting "stop_samba" via udhcpc_wan ...
Jul 19 16:28:14 Samba Server: smb daemon is stopped
Jul 19 16:28:15 wan_up: Find a 2.5G port on [eth0]
Jul 19 16:28:15 dnsmasq[4561]: bad IPv4 address at line 14 of /etc/dnsmasq-1.conf
Jul 19 16:28:15 dnsmasq[4561]: FAILED to start up
Jul 19 16:28:16 WAN(0) Connection: WAN was restored.
Jul 19 16:28:16 ping_target_with_size: Ping test is complete.
Jul 19 16:28:16 dhcp client: bound 94.xxx.xxx.xxx/255.255.252.0 via 94.xxx.xxx.xxx for 345600 seconds.
Jul 19 16:28:18 ping_target_with_size: Successful to ping target(94xxx.xxx.xxx) with size(79)
No DDNS entries in log and when I log into NO-IP dashboard, the old IP is still shown.
What the hell is going on?
I thought I had an issue with ASUS DDNS service, but this seems like a firmware/router issue.
Please advise.