CTF+FA on AC1900P or AC68P?

[marcusb]

Can anyone tell me defnitively whether the AC1900P or AC68P support CTF+FA NAT Accel? I find references to the 68P supporting it.. but they're always older posts. Did Asus remove support for this? I can't seem to enable it. I am up to date on both, running stock firmware (for aimesh, which I also tried disabling just to see if that was effecting it).

 

[doczenith1]

With my 68U B1 router I had both CTF+FA until I went to the 384 branch fw. Once I installed a 384 branch firmware I lost FA. I reverted back to a 380 branch fw and FA was present again. My guess would be that the other variants of the 68U would behave the same. I wouldn't be too concerned about not having FA. My 68U with only CTF could hit 940 Mbps WAN<>LAN.

Flash a 380 branch fw and then do a factory reset. It takes a few reboots before FA enables itself. It also takes a reboot after making any fw changes that affect FA before the GUI will show correctly whether or not FA is enabled.

 

[marcusb]

OK, thanks. It's not something I required.. I just was more curious why it wasn't working. I recall it working on my AC68P at one point, and my new 1900P wasn't working. When I checked the 68P I realized it was the same deal. Thought I was crazy.