heysoundude
Very Senior Member
I suspect there's some arcane logic to this, but if the majority of my client devices are showing up on the router with v6 addresses, why wouldn't the WAN address on Merlin's main page be v6?
If I'm using my ISP's native IPv6, why is my WAN address in Merlin IPv4?
- Thread starter heysoundude
- Start date
-
ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
Threads will not be locked, so posts may still be edited by their authors.
Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
heysoundude
Very Senior Member
I'm going to look into getting the UI/firmware to toggle somehow...hmmm...
Similar threads
Similar threads
-
When using DNSoverTLS with VPN, does Cloudflair see ISP or VPN IP?
- Started by Luboknok
- Replies: 6
-
Tutorial [SOLUTION] OpenVPN Client Split Tunnel Reverse Proxy Web Traffic using Nginx, DNSMasq, and IPTables
- Started by garycnew
- Replies: 10
-
Issue with Policy rules blocking all clients every 24 hours (using 384.19)- Started by cplay
- Replies: 4
-
-
-
-
[RT-AX88U] Issue with WiFi while using Link Aggregation- Started by zacofunny
- Replies: 9
-
-
-
Latest threads
-
PCE-AX3000: 2 cards, 1 is dropping connection- Started by ryan806
- Replies: 3
-
-
-
-
Sign Up For SNBForums Daily Digest
Get an update of what's new every day delivered to your mailbox. Sign up here!
