blackstone79
New Around Here
Hi all -
I have an ax58u operating in wireless router mode, and hooked up via ethernet i have an old ac68u set up in access point (AP) mode. I'm on the latest firmware for both as of 12/12/2020, which has the aimesh v2.0 with it. What is interesting is when I log onto the ac68u (the one set up in AP mode), I have the AiMesh v2.0 panel in the settings. It says there are no AiMesh nodes on the network, but i can do aimesh like things, like bind devices to that device (the ac68U). When I log onto my ax58u (the one operating in wireless router mode), it doesn't have this panel.... which would be nice to be able to bind things to it as well.
So i guess my question is, has anyone else noticed this behavior? I've done resets, etc.... and the panel shows up in the device set in AP mode....
Brian
I have an ax58u operating in wireless router mode, and hooked up via ethernet i have an old ac68u set up in access point (AP) mode. I'm on the latest firmware for both as of 12/12/2020, which has the aimesh v2.0 with it. What is interesting is when I log onto the ac68u (the one set up in AP mode), I have the AiMesh v2.0 panel in the settings. It says there are no AiMesh nodes on the network, but i can do aimesh like things, like bind devices to that device (the ac68U). When I log onto my ax58u (the one operating in wireless router mode), it doesn't have this panel.... which would be nice to be able to bind things to it as well.
So i guess my question is, has anyone else noticed this behavior? I've done resets, etc.... and the panel shows up in the device set in AP mode....
Brian