lighttpd using entware

[Rankdropper84]

Short and simple to the point. I cannot get my HTML code to work when using entware and lighttpd. I can't tell if I am posting my code to the wrong section of what. Can anybody else confirm that it isn't lighttpd? Would be greatly appreciated

FWIW I can paste my code into my Ubuntu PC and have it instantly show up on my localhost page.

 

[L&LD]

You don't provide or at least indicate what the code is, you don't state your router and you don't state what firmware your trying all this on. Ubuntu PC isn't a helpful spec either. Again, what version? And what are you pasting?

This it short, but not to the point at all, imo.

 

[Rankdropper84]

You don't provide or at least indicate what the code is, you don't state your router and you don't state what firmware your trying all this on. Ubuntu PC isn't a helpful spec either. Again, what version? And what are you pasting?

This it short, but not to the point at all, imo.

The code shouldn't matter, its just code. My router is an ac68u running 378.50. Sorry for the short reply. Most of my replies were in the entware thread and the person who was helping me basically told me to make a new thread.

Basically I would just like someone to confirm the location of the index.HTML that I should be editing so as to know I am editing the right one.

 

[TeHashX]

The code shouldn't matter, its just code. My router is an ac68u running 378.50. Sorry for the short reply. Most of my replies were in the entware thread and the person who was helping me basically told me to make a new thread.

Basically I would just like someone to confirm the location of the index.HTML that I should be editing so as to know I am editing the right one.

I told you to post in lighttpd post https://www.asuswrt.eu/lighttpd-web-server-with-php-support-through-entware/

Directory to edit is /opt/share/www/