Entware Okay to install entware update?

[scootertramp]

I am having an issue syslog-ng on my mesh nodes only. Twice now I have found syslog-ng not running and had to start it
on all three mesh nodes.

This is what I am seeing in the messages file.

Digging myself a bigger hole.
1) Tried rebooting node. ( syslog-ng stops after a period)
2) Attempted to reinstall scribe. ( same result)
3) unistall scribe,reboot and reinstall scribe. Went from bad to worst.
Now getting the following message on install.

 

[XIII]

Also Tailscale is downgraded (expected) and broken...

tailmon seems stuck on this:

error fetching current status: Failed to connect to local Tailscale daemon for /localapi/v0/status; not running? Error: dial unix /opt/var/run/tailscale/tailscaled.sock: connect: connection refused

EDIT: Fixed by running tailmon -setup and updating the Tailscale binaries again.

 

[scootertramp]

Digging myself a bigger hole.
1) Tried rebooting node. ( syslog-ng stops after a period)
2) Attempted to reinstall scribe. ( same result)
3) unistall scribe,reboot and reinstall scribe. Went from bad to worst.
Now getting the following message on install.

Ok, so I got scribe installed. Not sure how but there was an LD_LIBRARY_PATH set. I check my other two nodes and they do not have that set.
I just ran unset LD_LIBRARY_PATH and installed scribe. Now if it will just stay running.

 

[Viktor Jaep]

Entware only publishes updates 2 to 4 times per year. Today was the day.

From Russia, with love.

 

[Viktor Jaep]

This whole update process gives me Windows NT service pack vibes. Will be waiting for the weekend to update so I can handle all the fall-out in case the whole kit&kaboodle goes down.