I am using Merlin 384.14.2 on a RT-AC5300. I configured two OpenVPN clients to test with Windscribe and NordVPN. The setup went fine, I had "Force Internet traffic through tunnel" set and that worked well when turning off the client. I had specifically picked a workstation to test with. When I completed the testing, I removed the MAC from the configurations and applied the settings and turned them off. I rebooted the workstation and I am unable to access the WAN. So I defaulted the OpenVPN clients to remove them and still the same situation. I am not able to access the WAN from the client. I can access the client internally via VNC. Suggestions?
OpenVPN Client Not Clearing After Reset of Configuration?
- Thread starter zahroc
- Start date
Similar threads
Similar threads
Similar threads
-
Why doesn't the OpenVPN client support adding a shadowsocks proxy to it by default?- Started by Zakalwe
- Replies: 1
-
Accessing remote lan over site to site from a Openvpn client
- Started by elorimer
- Replies: 4
-
-
Please Help - OpenVPN Site-to-Site and Remote Access Setup – One Client, Two Servers (Asus RT-AC68U, Merlin 386.14_2)
- Started by bartasmosina
- Replies: 0
-
-
-
OpenVPN killswitch `prohibit` rule not applied via VPN Director / CLI (FW 3004.388.11)
- Started by XxUnkn0wnxX
- Replies: 4
-
-
-
Latest threads
-
D
-
Dual PS5 on Same Network – PSN Party Delay & Hit Registration Issues
- Started by Sarin
- Replies: 0
-
-
ASUS GT-BE98-Pro Firmware version 3.0.0.6.102_39260 does not include the CVE-2025-15101 fix!
- Started by cc666
- Replies: 4
-
Support SNBForums w/ Amazon
If you'd like to support SNBForums, just use this link and buy anything on Amazon. Thanks!
Sign Up For SNBForums Daily Digest
Get an update of what's new every day delivered to your mailbox. Sign up here!
Staff online
-
RMerlinAsuswrt-Merlin dev