What's new

Separate ip for usb modem in dual wan mode and 1 more problem

stylish_me

Regular Contributor
Hello everyone.
I am using rt-n66 in dual wan mode. Primary is my ISP, secondary is usb modem. Failover mode.
And i get 2 problems.

1. When switching from primary wan to usb modem - modem still gets ip, mask, gateway, dns and so on from primary wan settings. There is no option to enter separate settings (ip, gateway and so on) for usb modem as a secondary wan source. Any walkaround for it?
2. In failover mode i use watchdog that pings 8.8.8.8 for 10 minutes before making failback. But even if primary wan is still down, modem switches to primary wan every 10 minutes, fails to ping 8.8.8.8 and turns back to secondary wan. And same things happen all the time while primary wan is down. 10 minutes on secondary wan - 10 seconds on primary - 10 minutes on secondary and so on.
When i physically disconnect isp cable from the router - router stays on secondary wan for hours - untill internet cable is plugged in again.
How can i avoid switching from secondary to primary every 10 minutes when primary is still down?

Thanx!
 

Similar threads

Latest threads

Support SNBForums w/ Amazon

If you'd like to support SNBForums, just use this link and buy anything on Amazon. Thanks!

Sign Up For SNBForums Daily Digest

Get an update of what's new every day delivered to your mailbox. Sign up here!
Back
Top