Two AC68's one in AP mode, other in mesh.

[Terry Maxfield]

I have two AC68's in mesh acting as AP's, one connected to a fiber modem via powerline adapter.
The second AC68 (both have Merlin's latest) has random but frequent reboots.
Log included for help.

 

[ColinTaylor]

... has random but frequent reboots.

Are you sure you've attached the correct log file. I see only one reboot over 6 days and that appears to have been initiated from the GUI.

 

[OzarkEdge]

I have two AC68's in mesh acting as AP's, one connected to a fiber modem via powerline adapter.
The second AC68 (both have Merlin's latest) has random but frequent reboots.
Log included for help.

ISP gateway <powerline> AC68U AiMesh root node in AP Mode <wireless> AC68U AiMesh node

Did you reset the root node firmware before configuring it for AP Mode?

Have you tried removing/resetting the node and adding it back to the root node configuration?

OE

 

[Terry Maxfield]

ISP gateway <powerline> AC68U AiMesh root node in AP Mode <wireless> AC68U AiMesh node

Did you reset the root node firmware before configuring it for AP Mode?

Yes

Have you tried removing/resetting the node and adding it back to the root node configuration?

A few times.

OE

 

[OzarkEdge]

The second AC68 (both have Merlin's latest) has random but frequent reboots.

Has that node always been troublesome or just recently?

Does it have stable power?

Does it have wired clients connected to it? If so, does it continue to reboot with those cables disconnected?

If you swap it with the root node, does the issue follow it?

OE

 

[Terry Maxfield]

Has that node always been troublesome or just recently?

It has been troublesome for periods. I usually can reset, reconnect as mesh node, and its much more stable, until this time. Has not improved on those resets

Does it have stable power?

Directly into a new outlet in a new bedroom. Same as always.

Does it have wired clients connected to it? If so, does it continue to reboot with those cables disconnected?

None.

If you swap it with the root node, does the issue follow it?

Did that once previously, with improvements. Have not tried this time around, wondering if Im getting close to my end of useful life on these.