Wifi gtax6000

[Tech9]

If the walls are brick or concrete - nothing much you can do.

 

[ronorbar]

If the walls are brick or concrete - nothing much you can do.

Is it possible to change the transmission power?

 

[Tech9]

Not higher than what was preset for your region. Even if it was possible increasing the router's Tx power above certain limit won't translate into more range. Wi-Fi communication goes both ways and your clients won't be able to reach the router through 3 walls anyway.

 

[L&LD]

Thank you very much for the detailed answer, I will try everything. I have to use the existing router for 2 computers, I disconnect its wifi and connect it with a long cable to the ax6000 for the wan input

Can you give us a detailed as possible diagram of your setup?

Including the general region the router is used in, along with local specifics like wall/floor construction and anything else that may help us point you to a possible solution.

Are you able to move the routers around? Is the home wired (at all)? Again, more details will be helpful.

Once again; if you've been toggling settings back and forth on your current setup, it may be time to do a full reset and begin at the factory defaults again (some/many settings do not fully turn 'off' when simply toggled on/off via the GUI).

Do not change or enable settings without a reason. Provide the details as asked for above, perform a full reset, then ask for guidance when your router and network are in a good/known state (right now, we don't know where it's at).

 

[Spartan]

Is it possible to change the transmission power?

What's your Wireless card and what's the driver version?

 

[ronorbar]

First of all, many thanks to the forum for all the help, I installed the latest beta version and the router is now stable, the wifi reaches all areas of the house but there are places where it is really weak. I tried to change channels but it's the same, in my old Xiaomi router it was possible to set the transmission strength and it He would also reach the faraway regions.

 

[Tech9]

Remember what I told you before? Don't count on someone else's experience in different region and environment.

Best ax router

The best ax router you can buy today?

www.snbforums.com

 

[ualdrivr]

Need help, gtax6000, wifi signal is very weak and also does not recognize frequency 5.
3.0.0.4.388.22068

Just to put my two cents in, 388.22068 firmware has major issues. I would flush the older firmware into the router and see what happens, version 388.21617. That's what I did and I'm still running that version until they come up with a newer one. Like @Spartan said, there's the BETA version out, but I'm waiting for the non BETA to be published.