XT8 - “not mesh client, can’t update it’s ip”

[wags1]

I keep seeing the subject line in my log. Sometimes is wireless clients sometimes wired. Anybody know what it means. I have an HP printer (OfficeJet Pro 9015e), which is a wired client not wireless, that is giving me pages and pages of that line in the log.

 

[RogerSC]

Same messages here, was using 41793 firmware. Reverted to 26044, reset, and don't see this message anymore, everything works. Don't know if it's significant or not, but also had a spontaneous reboot with 41793 (with "crashlog"), so that was the other reason that I reverted *smile*. No problems with 26044, although miss some of the features of AiMesh 2.0. I figure it'll come back around for me in a more stable firmware version, though.

 

[Thirteen]

I'm getting the same message on 41793, about 99% of which are for our DirecTV DVR. It still works though, so I just ignore it.

 

[tglesel]

Same messages starts to occur from time to time in the syslog on my Ax92U ver 41712. When I reboot the AiMesh node (also AX92U) the message stops in syslog. Are you also running AiMesh setup?

 

[wags1]

Same messages starts to occur from time to time in the syslog on my Ax92U ver 41712. When I reboot the AiMesh node (also AX92U) the message stops in syslog. Are you also running AiMesh setup?

I am running in AiMesh mode. After I did a power cycle of both the router and the mesh node I’m no longer seeing those entries in the log.

 

[RogerSC]

You're lucky, I tried both full factory reset and power-cycling both nodes, and was getting way too many of those messages.

Guess it's one of those YMMV things *smile*.

Note: Just tried 41793 more time for luck, full factory reset, then manual reconfiguration, followed by power-cycle of both nodes and still got those same messages. Wags1, want to come over to my house and power cycle my XT8's *smile*?