Bionic
Occasional Visitor
Just got an RT-AC68U and I am running Merlin 378.53_0 . I bought this to replace an existing router. But I have noticed that a few configurations that my current router has, I can't config in the AC68U. I have contacted ASUS but the Level 1 tech was unable to help me. The Level 1 tech gave me a case number and said that a level 2 tech will have to contact me. The question that I posed to the Level 1 tech was if the configurations that I need, can be applied via telnet/ssh...??
One to One NAT
I have a block of wan IP addresses from my internet provider that I need to resolve to certain lan ip's behind the AC68U. I don't see a way to configure this on the AC68U.
Dual Wan (access configured by group of ip's)
I have a dual Wan setup. Certain lan IP's wan traffic goes out of the primary wan, and certain IP's wan traffic goes out of the secondary wan. I see where I can enable the dual wan on the AC68U. I also see where to enable the load balance, I also see where I can then set the rules for specific Lan IP's to use a certain wan.. But I don't see any where I can specify a group of Lan Ip's to use a certain wan. Example: I need ip's 192.168.1.50 - 192.168.1.99 to use the primary wan, and I need 192.168.1.100 - 192.168.1.200 to use the secondary wan. How do i configure that with out having to type each individual ip address in the rules list?
One to One NAT
I have a block of wan IP addresses from my internet provider that I need to resolve to certain lan ip's behind the AC68U. I don't see a way to configure this on the AC68U.
Dual Wan (access configured by group of ip's)
I have a dual Wan setup. Certain lan IP's wan traffic goes out of the primary wan, and certain IP's wan traffic goes out of the secondary wan. I see where I can enable the dual wan on the AC68U. I also see where to enable the load balance, I also see where I can then set the rules for specific Lan IP's to use a certain wan.. But I don't see any where I can specify a group of Lan Ip's to use a certain wan. Example: I need ip's 192.168.1.50 - 192.168.1.99 to use the primary wan, and I need 192.168.1.100 - 192.168.1.200 to use the secondary wan. How do i configure that with out having to type each individual ip address in the rules list?