Recent content by Jim Kirk

I’m back to Beta testing the Linux Box Geochron program now and the mesh connection works, albeit with limitations, per my earlier stated conclusions.

No.

I attached to the first AiMesh J-2.4G connection, see Pic 1. The connection was stable for the last 18 hours. I confirmed that the Linux box was connected to my AiMesh node called TV-Room which is physically close to my Geochron Linux box. . Then I turned off the TV-Room node radios (Wifi...

I was expecting consistency among all clients, i.e. 1 SID showing for an AiMesh system, shouldn't matter what the box OS is. The multiple AiMesh SID's for the Linux box may or may not result in a connection stability problem for the Linux box because I haven't tried connecting to any of the...

I have an AiMesh network with the components shown in my Signature. When my Wifi clients (e.g. iPhone, iPad, laptop, etc.) view available networks my Mesh system shows up with just a single SID on the network connection screen of the client. No problems here, this is just as it should be. On...

Hi @VANT, I am using FW: 3.0.0.4.384.32799 for my (3) AC5300's (see signature) because I really want 3 bands for my AiMesh setup with my use of a wired backhaul. Will the new FW "...in a couple of weeks" be: Available for the AC5300's? Bring back the 3 Wifi bands if the AiMesh users uses a...

Have there been any developments on this issue? Seems like further work on the next FW >45149 has stopped.

Well LimJK you continue to have my attention :). I second LimJK on his request. I am also waiting for the next FW release for my 3 RT-AC5300's so I may solve the problem I reported with FW 45149 here...

LimJK, :D:D:D I second, and third, etc. etc. that hope :D:D:D Jim

LimJK, Too bad we cannot turn off the dedicated and inaccessible 5G backhaul band in 45149 when using an ethernet backhaul. I could then have pinned down the issue very quickly. AiMesh was running so well, and through the last several FW upgrades, there were no problems upgrading. I was...

Hi LimJK, Take a look at my post on my upgrade problem for FW 384.45149 for 3 RT-AC5300's. I had a big speed problem at the parent router which was sometimes as bad as no upload connectivity. https://www.snbforums.com/threads/3-rt-ac5300s-upgraded-384-45149-quickly-downgraded-384-32799.50296/...

See signature for my RT-AC5300 configuration. This reference thread also describes RT-AC5300 upgrade issues: https://www.snbforums.com/threads/asus-rt-ac5300-firmware-version-3-0-0-4-384-45149.50244/ I have about 25 wired clients and 15 wireless. Before the upgrade, I was set up with a...

My mesh setup is shown in the signature. Upgraded today, 7/11/2018. Used the Web GUI to update the mesh (parent and two nodes) from 21045. Single click did all 3 routers. No reboot needed. Took about 5 minutes from clicking Administration>check update>then click on update. When parent...

All my nodes are ethernet connected to the parent. I found that if there are switches between the node and the Parent, a connection priority of "Auto" gives occasionally disconnects of the node with it resulting in "offline" as seen in the parent. I also observed that with Auto connection...

I upgraded today. Pleasantly surprised all went as well as it did. Same experience as @Neil62. Update completed via Web GUI, straight upgrade, no factory reset/initialize done for the upgrade. Update notification of firmware was from the Web GUI. AiMesh running smoothly, setup is shown in...