Recent content by node

I figured it out

I am running 386.7_2 on my AC5300 and running my own OpenVPN server located 6000 miles away from my current location. The Router VPN shows connected, and I have check DNSLEAK and no issues there. My IP phone has it owns OpenVPN configuration and CA : CRT, & RSA keys files also, and connect to...

Colin thanks was able to do it

I have to apologized and clarify my post a bit after reading. I need to add a device to one of my already set VPN's in my router using the command line. Not set a VPN client up. So I need to know exactly where I put this device IP address.

That's the easy part I reckon. RT-AC5300 386.5_2

I would like to add one more client on my Network to my OpenVPN in my Router via ssh command line. I would like to know the syntax. Also the syntax to open and delete ports via command line. I know the VPN server and the Client local IP address on my network. I can logged into the router via my...

Smooth like silk, dirty upgrade on both my RT-AC5300 & RT-AC68U.

I removed Diversion & Entware from the AC5300 Router.; now when the laptop is connected via my home VPN I am able to use any device local IP given by the AC68U to access. I do not know if it is Diversion or Entware or both, will reload and try again. Strange firmware 386.3 the AC5300 had...

Just disconnected (4) and left one server connected to my AC68U. Still no joy. Noted they were all connected with 386.3 and all worked fine. Using TUN, never used TAP. This therefore eliminates any conflict issues. This one is really baffling me. Also note I can always connect to my OVPN...

I run ASUS AC5300 with firmware 386.4 recently updated from 386.3. I have (5) OVPN configured set in the AC5300 as was before. Two of which are my own VPN servers located remotely at home 6,000 miles away connected to ASUS AC68U running firmware 386.3. I built theses servers and been using them...

Thanks Colin, was a little more than 63K from the 65.2K, ran the code, now sitting at 52.2K. A significant gain. Thanks a mill. node

I too running the latest RT-AC68U Merlin firmware and getting the low NVRAM exclamation flashing. Check indeed low. My issue is I am 4000 mile from my router and cannot do a factory reset and login back in to reconfigure. Attached is my NVRAM variables, can I wipe or move the heavy users out?

I have 3 TV boxes at my home, they are all come with one port by default set, which I cannot change in the firmware. I can gain access directly with DDNS client running on the boxes. With IP address and Putty ,port and Protocol. I cannot open the same port on the router to three different...

I am running the AC68U with Merlin 376.44 which works well, however, I will like to know how to set under Port Forwarding the SAME port to other IP addresses on the DHCP? When I try I get an error saying the port is used. Any help would be appreciated.

Big hello to all; I am planning my move from DD-WT to Asuswrt-Merlin. I have been reading for the pass few days, and feel it is time I transition. I have not obtain my Asus router as yet but will in a few days time; I am looking at the RT-AC66R at Best Buy. ( Any input advise would be...