Recent content by slyderz

I noticed a setting in the firewall section for ipv4 firewall. Isn't the setting under general for the ipv4 firewall?

I will give this a try and see if it fixes the issue for me.

Has anyone been getting this in the syslog? It seems to be related to adaptive qos. I don't get this in the log when adaptive qos is off. May 7 08:03:46 kernel: ------------[ cut here ]------------ May 7 08:03:46 kernel: WARNING: CPU: 3 PID: 6200 at net/sched/sch_htb.c:568...

Is the wireless log broken for anyone using firefox or ios devices? It works fine when I use chrome.

I tried to send feedback from the feedback page and to [email protected] but it came back undeliverable. It said the mailbox was full.

I've been messing with this firmware a bit more. When I shut Ai Protection, Adaptive QoS and Traffic Analyzer off the errors stop but as soon as I turn one of them on they start showing up again. The same thing happens after a factory reset as well.

I reflashed the router and it still has the errors. I switched it back to a previous firmware and it no longer has these errors.

Since updating my rt-ac1900p I've been getting a squashfs error in my log every 2 min. I've tried rebooting and factory resetting. Mar 29 23:17:21 kernel: SQUASHFS error: Unable to read page, block 187b0a6, size 4f78 Mar 29 23:19:21 kernel: SQUASHFS error: xz_dec_run error, data probably...

I haven't had any luck.

I’ve reset it a few times and I have tried flashing it again. When I put 380.7743 back on it everything works fine. Sent from my iPad using Tapatalk Pro

This is after a couple hours on my AC68P.

AiProtection, web & apps filters, traffic analyzer, adaptive qos and web history all seem to be broken for me. They all turn on but they don’t seem to be doing anything. Sent from my iPhone using Tapatalk Pro

Aimesh seems to be working fine. I can't get web history or the traffic analyzer to work. They both turn on but nothing shows up. This is on a rt-ac68p.

Thanks for fixing the GUI. I noticed when setting up it wanted to enable smart connect is that something new for the ac68p? I didn't see any settings for it in the GUI. The network map said to check my internet connection which was working fine. I enabled ipv6 and that didn't want to work. It...

I flashed from 3.0.0.4.380_7743 and this was on my primary router. I wasn't able to access the gui after flashing or after a factory reset.