ipv6

Was using the older asus rt-ac3200 and was getting ipv6. Switched to a asus rt-ac5300, no ipv6 no matter what I do. Comcast tells me that everything is "enabled" on their end for the cable modem to be handing out ipv6. The cable modem is a arris sb6183. Any pointers?

I upgraded from a Linksys E3000 running Tomato to an ASUS RT-AC88U first running the stock firmware and then upgraded to Merlin. With Toastman and the E3000 I never had any problems with ipV6 and Comcast. It just worked. With the AC88U I'm having problems where IPv6 works for awhile and then...

Short description: I'm unable to access ipv6 only servers in the internet, even though I have a native IPv6 address. Ping6 does work between local computers and computer <-> router, however not between computer and internet (tested with ipv6.google.com) or even router and internet (timeout, 100%...

I have RT-AC66U, and few months ago I've enabled ipv6. It's been working fine for many months. Yesterday I needed to test some software with ipv6 and i realized i don't have IP assigned. at this point I had 380.59 installed and ipv6 page was showing blank for LAN IPv6 Address, LAN Prefix...

Good insight here... http://www.kloepfer.org/ipv6-homenet.html

Hello, I have searched the Ubiquiti community forums but the information there is hard to find as the process to enable IPv6 support is different between EdgeOS versions and pretty situation specific. My EdgeRouter-X has the lastest FW (1.8.5) and my ISP is Comcast. With my setup eth0 is WAN and...

Hi All, Thanks for the Asus-merlin firmware - I've found it really useful. I've been using ipv6 to connect two locations together - both sides use an AC68U with the Asus-Merlin firmware. The one site is only reachable via ipv6, so I've been seeing how to make everything work that way...

Teredo can be a pain when sorting out IPv6 issues on your LAN/WLAN... Quick debug hint - do this on any/all Win7/8/10 machines... howto: 1. Open a command prompt with administrator privileges (Start->Accessories->right click on Command Prompt, choose Run as Administrator): 2. Issue the...