Hello,
I'm hoping someone here can help me.
I've got an AC88U and 3 x AC3000 running firmware version 3.0.0.4.386_45898. I've recently been having no end of problems with the nodes dropping off the network, losing performance (80%) and most recently not handing out DHCP leases!
I'm actually at the point where the pain of re adding the nodes (I think I've done this at least 3 times) is so great I figured I'd get some help from the community
Where am I going wrong?
Surely you should be able to reboot your router without your aimesh needing to be rebuilt? (I did move all the AC3000 nodes to within a meter of the Router only to be met with node connection failures) The Only way I could consistently add the nodes was via the WAN port and a RJ45 during setup.
I don't know what to do. half tempted to just set them up as repeaters?
Any advice greatly appreciated.
T1b
I'm hoping someone here can help me.
I've got an AC88U and 3 x AC3000 running firmware version 3.0.0.4.386_45898. I've recently been having no end of problems with the nodes dropping off the network, losing performance (80%) and most recently not handing out DHCP leases!
I'm actually at the point where the pain of re adding the nodes (I think I've done this at least 3 times) is so great I figured I'd get some help from the community
Where am I going wrong?
Surely you should be able to reboot your router without your aimesh needing to be rebuilt? (I did move all the AC3000 nodes to within a meter of the Router only to be met with node connection failures) The Only way I could consistently add the nodes was via the WAN port and a RJ45 during setup.
I don't know what to do. half tempted to just set them up as repeaters?
Any advice greatly appreciated.
T1b