AMTM showing scripts as installed after Firmware reboot

[thomaswillner]

After installing the original ASUS Firmware and then installing Merlin again it still shows all the tools as "open" and then they don't work. Why is that? Please help

 

[L&LD]

After doing a full reset of the router (not just re-installing the firmware you want to use) and not using a saved backup config file, did you simply plug in the USB drive you previously used for amtm and the scripts?

To start really fresh, do the full reset as per the link below for your router, and format the USB drive into a PC and format it to NTFS before you plug it into the router. Do not use a saved backup config file. Do a minimal and manual configuration to connect to your ISP and secure the router.

[Wireless Router] When Standard Reset Isn’t Working: Hard Factory Reset - Models list | Official Support | ASUS Global

Merlin on ASUS ax86U Question

I have an ASUS AX86U and contemplating the installation of Merlin firmware. The DDNS settings on the AX86U are limited to select dns providers. If I install Merlin, will I have more flexability (choices) with the DDNS Settings? Thanks in advance!

www.snbforums.com

Am I all set to start fresh with the latest stable release? And a request for L&LD...

After creating the checklists two weeks ago to save the pages with settings, I've made all the screenshots (I think at least) of all the relevant guides written by @L&LD and the very useful tip by @netware5. The only thing is, those guides are great, except when you'll be offline at least for a...

www.snbforums.com

L&LD

www.snbforums.com

 

[thomaswillner]

OK, thank. I wonder why AdGuard Home shows as uninstalled FYI I formatted the USB ext4. So I think ATMT is showing this because it's in the database on the router as active?

 

[thelonelycoder]

OK, thank. I wonder why AdGuard Home shows as uninstalled FYI I formatted the USB ext4. So I think ATMT is showing this because it's in the database on the router as active?jYou need to also format the Jeffs partition under Administration/System

You also need to format the jffs partition under Administration/System to clear out the scripts that install into it.

 

[ColinTaylor]

OK, thank. I wonder why AdGuard Home shows as uninstalled FYI I formatted the USB ext4. So I think ATMT is showing this because it's in the database on the router as active?

I already answered this question in your other thread. If hadn't created a duplicate post you would have seen it already.