Asus Lyra AC220 setup?

[Courage]

Hello!

So, my setup is like this:

1. I have an ISP modem (PPPoE), that also acts as a DHCP.
2. I have 2 Lyra AC2200 that I want to be connected via ethernet cable, each to the same switch (classic AP mode + WIFI transition).

Modem -> Switch > 3 Lyra AP's

What settings should I use?

Thank you

 

[OzarkEdge]

Hello!

So, my setup is like this:

1. I have an ISP modem (PPPoE), that also acts as a DHCP.
2. I have 2 Lyra AC2200 that I want to be connected via ethernet cable, each to the same switch (classic AP mode + WIFI transition).

Modem -> Switch > 3 Lyra AP's

What settings should I use?

Thank you

Assuming the modem is your router and the Lyra's do AiMesh, I believe your options are wired/wireless AiMesh in AP Mode (wired AiMesh AP + wired/wireless AiMesh nodes); or, 3 wired APs. AiMesh may not like the switch.

This FAQ might help [AiMesh] How to set up ASUS AiMesh or ZenWiFi Mesh Ethernet backhaul under different conditions ? (Advanced setup with network switch) | Official Support | ASUS Global

OE

 

[Courage]

I'll try, but from What I see, Lyra does not have so many options.
I've tied AP Mode and for some strange reason, WIFI was gone but enabled in the interface.

 

[OzarkEdge]

I'll try, but from What I see, Lyra does not have so many options.
I've tied AP Mode and for some strange reason, WIFI was gone but enabled in the interface.

Be sure to start with current firmware, reset to factory defaults.

Reset FAQ
Reset Button/webUI Restore
WPS Button Hard Reset

OE

 

[Courage]

I've reset all to default and put the newest firmware:
3.0.0.4.384.46630 2021/05/14

So, with older, beta FW (
9.0.0.4.384_46629 BETA 2021/02/05 ), I got this:




With the newest fw ( 3.0.0.4.384.46630 - 2021/05/14) I got this:

 

[OzarkEdge]

I've reset all to default and put the newest firmware:
3.0.0.4.384.46630 2021/05/14

So, with older, beta FW (
9.0.0.4.384_46629 BETA 2021/02/05 ), I got this:

View attachment 36494


With the newest fw ( 3.0.0.4.384.46630 - 2021/05/14) I got this:

View attachment 36495

Be sure to reset the firmware after you install it.

Your pic suggests a webUI tab is missing from your build.

OE