Hi guys.
I have 2x ASUS RT-AC66R. First one is set as router and second one as repeater. Repeater is rebooting every few minutes and can't figure it out why.
Firmware is last official from asus 3.0.0.4.380_3264. I had Merlin's firmware before on repeater but had same issue. So I think it's not firmware issue. May be some settings on router or repeater... I don't know. Both are on same channels on 5Ghz wifi. I tried change channels... use different router... dissable 5Ghz or 2.4Ghz... same issue. I can't use second one as bridge mode, only as repeater.
Here is what I get in System log:
May 27 17:49:43 notify wanduck: wlc_state change!
May 27 17:49:44 rc_service: ntp 433:notify_rc restart_diskmon
May 27 17:49:44 disk_monitor: Finish
May 27 17:49:44 disk monitor: be idle
May 27 17:49:44 rc_service: udhcpc_lan 450:notify_rc start_dnsmasq
May 27 17:49:44 notify wanduck: wlc_state change!
May 27 17:49:47 start_nat_rules: apply the nat_rules(/tmp/nat_rules_repeater)!
May 27 17:50:09 crond[262]: time disparity of 433309 minutes detected
I know there was some disscusions about that issues before, but I spend all day reading and searching but found nothing for me.
I hope someone can help me.
Thank you guys.
I have 2x ASUS RT-AC66R. First one is set as router and second one as repeater. Repeater is rebooting every few minutes and can't figure it out why.
Firmware is last official from asus 3.0.0.4.380_3264. I had Merlin's firmware before on repeater but had same issue. So I think it's not firmware issue. May be some settings on router or repeater... I don't know. Both are on same channels on 5Ghz wifi. I tried change channels... use different router... dissable 5Ghz or 2.4Ghz... same issue. I can't use second one as bridge mode, only as repeater.
Here is what I get in System log:
May 27 17:49:43 notify wanduck: wlc_state change!
May 27 17:49:44 rc_service: ntp 433:notify_rc restart_diskmon
May 27 17:49:44 disk_monitor: Finish
May 27 17:49:44 disk monitor: be idle
May 27 17:49:44 rc_service: udhcpc_lan 450:notify_rc start_dnsmasq
May 27 17:49:44 notify wanduck: wlc_state change!
May 27 17:49:47 start_nat_rules: apply the nat_rules(/tmp/nat_rules_repeater)!
May 27 17:50:09 crond[262]: time disparity of 433309 minutes detected
I know there was some disscusions about that issues before, but I spend all day reading and searching but found nothing for me.
I hope someone can help me.
Thank you guys.