blademan007
New Around Here
Hi all,
New to Asus merlin and asus family. Coming from Google wifi, and plenty of linksys/dd-wrt/tomato.
If I configure router from start into AP mode, I'm unable to add node. AI-mesh add process detects device, goes through mesh configuration progress gui, and then show failure page.
I've tried using asus-merlin fw for both units, as well as asus fw for both. Same result.
TIA
New to Asus merlin and asus family. Coming from Google wifi, and plenty of linksys/dd-wrt/tomato.
- 2 new RT-AX58
- Installed latest Asus Merlin firmware
- When adding node, node WAN is plugged into router LAN, and node is detected with no problems.
- Goal is to setup 2 AX58 into AP mode. Setup AI-mesh with ethernet backhaul. Change them to different subnet 192.168.86.0/24 (migrating from Google wifi). Give both devices statics of .15 and .16.
If I configure router from start into AP mode, I'm unable to add node. AI-mesh add process detects device, goes through mesh configuration progress gui, and then show failure page.
I've tried using asus-merlin fw for both units, as well as asus fw for both. Same result.
TIA