determining iface media type

[kfahoo]

is there any way to determine interface media type with cli on asuswrt?
weather it's 100base, 1000base etc

 

[ColinTaylor]

# ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supported pause frame use: Symmetric Receive-only
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: Yes
        Advertised FEC modes: Not reported
        Link partner advertised link modes:  100baseT/Half 100baseT/Full
                                             1000baseT/Half 1000baseT/Full
        Link partner advertised pause frame use: Symmetric Receive-only
        Link partner advertised auto-negotiation: Yes
        Link partner advertised FEC modes: Not reported
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 12
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: Unknown
        Link detected: yes

 

[kfahoo]

muchas gracias

 

[ColinTaylor]

What specifically are you trying to do? There may be better ways than using ethtool.

 

[kfahoo]

I needed just that but you can share some tips