stamzrat10
Occasional Visitor
Hi friends, this is my first post, therefore, I would like to say that the Merlin firmware is awesome. I really appreciate all the work and development invested in it. thanks to it I have gained enough knowledge to set up a very convinent setup at home.
I have an RT-AC86U, I use NordVPN and have about 3 concurrent OpenVPN clients working at the same time.
At the moment, I only manage to give very specific routing rules, e.g have printer connect to OpenVPN#1 TV to OpenVPN#2 phone to OpenVPN#3, etc. But if I try to have all connections tunneled by default through OpenVPN #1, unless they have rules in OpenVPN #2 or 3 it fails and the internet connection drops.
I use 192.168.1.0/24 0.0.0.0 VPN at OpenVPN#1 and add all the rules from the other OpenVPN clients as xx.xx.xx.xx 0.0.0.0 WAN.
With all clients I use Accept DNS Configuration Exclusive
Force Internet traffic through tunnel Policy Rules (strict)
No NAT or private IP
and the subnets and ports are different and not overlapping
in other words, how do I configure all connection to be tunneled by default through OpenVPN client #1 unless stated otherwise in OpenVPN client 2 or 3.
When I browsed through the forum I couldn't find the answer so maybe others will benefit from this thread as well.
John
I have an RT-AC86U, I use NordVPN and have about 3 concurrent OpenVPN clients working at the same time.
At the moment, I only manage to give very specific routing rules, e.g have printer connect to OpenVPN#1 TV to OpenVPN#2 phone to OpenVPN#3, etc. But if I try to have all connections tunneled by default through OpenVPN #1, unless they have rules in OpenVPN #2 or 3 it fails and the internet connection drops.
I use 192.168.1.0/24 0.0.0.0 VPN at OpenVPN#1 and add all the rules from the other OpenVPN clients as xx.xx.xx.xx 0.0.0.0 WAN.
With all clients I use Accept DNS Configuration Exclusive
Force Internet traffic through tunnel Policy Rules (strict)
No NAT or private IP
and the subnets and ports are different and not overlapping
in other words, how do I configure all connection to be tunneled by default through OpenVPN client #1 unless stated otherwise in OpenVPN client 2 or 3.
When I browsed through the forum I couldn't find the answer so maybe others will benefit from this thread as well.
John